Venting Installation
instructions
Continued
Minimum Pipe | Siding Standoff | |
Overlap 11/4" | ||
|
| ||
Pipe | Screws | |
Wall |
| |
Firestop |
| |
Maintain 1" |
| |
Minimum Air | High Wind | |
Space Around | Termination | |
Outer Pipe When | Apply | |
Penetrating a Wall | ||
Mastic to | ||
| ||
| Outside | |
10" x 10" Framed | Edge of | |
Standoff | ||
Opening |
|
Exterior Wall with Vinyl Siding
Figure 13 - Typical Horizontal Termination Cap Mounting with Additional Siding Standoff Installed
Horizontal Termination Configurations Figures 14 through 18 show different configura- tions and alternatives for venting with horizontal termination. Each figure includes a chart with critical minimum and maximum dimensions which MUST be met. IMPORTANT: If using a venting configuration of only horizontal venting with no vertical run, a 1/4" rise for every 12" of run toward the termination is required.
NOTICE: Do not seal termination cap to vent pipe. Cap must be removable for vent inspection and maintenance.
WARNING: Never run vent downward as this may cause excessive temperatures which could cause a fire. Operation of improperly installed and main- tained venting system could result in serious injury, property damage or loss of life.
GROUND FLOOR INSTALLATION
Recommended Applications:
•Installation using cabinet surrounds
•Through the wall using round or square termina- tion (up to 12" horizontal pipe)
•NOT FOR CORNER INSTALLATION
Adjustable
Horizontal Pipe 12" Max. 45° Elbow
High Wind
Square
Termination
Wall Firestop
Square Termination
Vertical (V) | Horizontal (H) |
32" min. | 17" Max. |
Exterior Portion
45° Elbowof Wall Firestop
(Round
WallTermination
Firestop Only)
Slide Ring
Over Elbow to Complete Connection
Round Termination Cap
Round Termination
(Kit HTK Shown)
*If installing this fireplace at altitudes of
4000 feet and above, it is recommended that an additional vertical height of 6" be added to the vent system.
Figure 14 - Horizontal Termination Configuration for Square and Round Terminations
www.desatech.com | 11 |