Fireplace
Installation
Continued
8.Pull ember material apart into pieces no larger than a dime. Place these pieces loosely and sparingly directly onto exposed section of front burner and along space between burner and grate prongs (see Figure 45). This will create glowing ember appearance as flame touches ember material. Do not block air slots by using too much ember material in one area. It is not necessary to use all of ember material provided.
9.Close glass door, lock door latches, replace screen and close louvers (see Removing/Replac- ing Glass Door, steps 5 through 7, page 23).
WARNING: The glass door must be securely in place before running this fireplace. Do not run this fireplace if glass is missing or broken.
optional Remote control INSTALLATION (model WRC)
Note: If using optional wireless
1.Open lower louver panel of firebox.
2.WRC model receiver does not require a bat- tery. Receiver can be installed by first plugging short extension cord into fireplace receptacle. Plug receiver unit into extension cord. Finally plug ignition module plug into receiver unit (see Figure 46).
3.Activate remote handset battery by removing insulating tab on back of handset (see Figure 47). Battery is included
4.Once battery is activated unit is ready to use.
5.Close lower louver panel.
Fireplace |
|
Receptacle | Remote |
| Control |
| Receiver |
Ember Material
Figure 45 - Placing Ember Material on
Burner
WALL SWITCH INSTALLATION
Installation of a wall switch allows you to activate gas control valve and turn fireplace on and off. The wall switch is to be connected to incoming 120 volt regular household wiring that supplies electricity to fireplace. Refer to wiring diagram, page 27.
Extension | Ignition Module |
Cord | Plug |
Figure 46 - Installing the WRC Remote
Receiver
Battery Cover
12 Volt Battery
Back of
Handset
Pull to Remove
Insulation Tab
Figure 47 - Installing Battery into Back of
Handset
26 | www.desatech.com |