Desa (V)T36EPA Local Codes, Product Identification, Product Features, High traffic areas

Page 4

Safety information

Continued

2.If you smell gas

shut off gas supply

do not try to light any appliance

do not touch any electrical switch; do not use any phone in your building

immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier's instructions

if you cannot reach you gas supplier, call the fire department.

3.Never install the fireplace

in a recreational vehicle

in windy or drafty areas where curtains or other combustible (flammable) objects can make contact with the fireplace front

in high traffic areas

4.Turn appliance off and let cool before servic- ing, installing or repairing. Only a qualified service person should install, service or repair this fireplace. Have fireplace inspected annu- ally by a qualified service person.

5.You must keep control compartments, burn- ers and circulating air passages clean. More frequent cleaning may be needed due to ex- cessive lint and dust from carpeting, bedding material, etc. Turn off the gas valve and pilot light before cleaning fireplace.

6.Have venting system inspected annually by a qualified service person. If needed, have venting system cleaned or repaired.

7.Do not use any solid fuels (wood, coal, paper, cardboard, etc.) in this fireplace.

8.This appliance, when installed, must be electri- cally grounded in accordance with local codes or, in the absence of local codes, with the

National Electrical Code, ANSI/NFPA 70 or the Canadian Electrical Code, CSA C22.1.

9.Do not use fireplace if any part has been ex- posed to or under water. Immediately call a qualified service person to arrange for replace- ment of the unit.

10.Do not operate fireplace if any log is broken.

11.Do not operate fireplace with glass door removed, cracked or broken.

12.Provide adequate clearances around air openings.

Local Codes

Install and use fireplace with care. Follow all local codes. In the absence to local codes, use the cur- rent National Fuel Gas Code ANSI Z223.1/NFPA 54* (USA) or the current CSA-B149.1 Installation Code (Canada).

*Available from:

American National Standards Institute, Inc.

1430 Broadway

New York, NY 10018

National Fire Protection Association, Inc.

Batterymarch Park

Quincy, MA 02269

Product

Identification

Upper Louver

Flue Collar

Panel

 

Nailing

Log Set

 

Flange

 

Glass Door

Assembly

Glowing

Embers

Control

Valve

Lower

 

 

Louver

Grate

 

Panel

Assembly

 

ON/OFF/REMOTE Switch

Lava Rock

(Optional Installation)

Blower Switch

 

 

(Optional

Installation)

Figure 1 - Direct-Vent Fireplace

Product Features

These are a few facts that can help you understand and enjoy your direct-vent fireplace:

The venting system may be routed to the outside of your home in several ways. It may vent through the roof (vertical) or it may vent to an outside/exte- rior wall (horizontal). The vent pipe installation is very important to allow for proper operation. You must follow the venting instructions very carefully for either vertical or horizontal applications.

This fireplace may be installed in any room of your house provided all local codes and these installation instructions are followed.

www.desatech.com111251-01E

Image 4
Contents What to do if YOU Smell GAS Table of Contents Safety InformationSafety Information Product Features Local CodesProduct Identification High traffic areasLocation and space requirements Pre-Installation PreparationProper clearances must be maintained Clearances Framing and finishingFront Top of Standoffs Vent See venting Venting clearancesLocation of Termination Cap Balcony with Perpendicular Side WallVenting Installation Instructions Installation PrecautionsInstallation Planning Installing Horizontal Vent Cap Noncombustible Exterior Ground Floor Installation 32 minSnorkel Termination Installation Recommended Applications Corner ground floor installationHorizontal System Installation Using TWO 90 Elbows Flat Ceiling Installation Installation for vertical terminationConnect a section of pipe and extend up through the hole Twist-lock the vent cap onto the last section of vent pipe High Altitude Installation Vertical VentingDesa Venting Accessories Desa ElbowsDesa Terminations Number DescriptionFireplace Installation Installing optional blower accessoriesModel BK Installation Check GAS TypeModel BKT Installation Plug in blower power cord to duplex outletBlower Wiring Diagram Installing Gas Piping to Fireplace LocationInstallation Items Needed Connecting Fireplace to GAS Supply Checking GAS ConnectionsPressure Testing Fireplace Gas Connections Test Pressures Equal To or Less Than Psig 3.5 kPaCleaning Glass Door Removing/Replacing Glass DoorRemoving Louver Panels Removing Glass DoorInstalling logs, lava rock and glowing embers Close top and bottom louversInstalling Log No Wall Switch Installation Optional Remote control Installation model WRCOpen lower louver panel of firebox Pilot Gas Wiring DiagramLine Operating Fireplace For your safety Read before lightingLighting Instructions Inspecting Burners To Turn OFF GAS To ApplianceOptional Remote Operation Burner Flame PatternCleaning Maintenance Glass DoorPilot and burners LogsCleaning and Maintenance TroubleshootingObserved Problem Possible Cause Remedy Venting systemGas leak. See Warning Tery power is low Remote Improper log placementClean out air holes at burner Glass soots Flame impingement on logsIllustrated Parts Breakdown Parts List Illustrated Parts Breakdown KEY Description Replacement Parts Service HintsTechnical Service SpecificationsAccessories Keep this Warranty Warranty InformationLimited Warranty DIRECT-VENT Fireplace