Desa CD32M-1, CD32M-2, CD36M-A1, CD36M-A2 Installing LOG SET, Models CD32M and CD36M-A Series

INSTALLATION

Continued

3.Undo latches located on top and bottom of firebox (see Figure 17). Carefully swing door to the left. The glass door is securely mounted to the firebox with 5 screws.

Glass

Locating

Holes

Spring

Latch

Bottom Louver

Figure 16 - Removing Louvers

Open

Close

Figure 17 - Spring Latches

INSTALLING LOG SET

Each log is marked with a number in the following diagram. These numbers will help in identify- ing the logs when installed. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with fireplace.

Models CD32M and CD36M-A Series

1.Place log #1 (back log) on top of grate as shown in Figure 18 for the CD36M-A Series. Log #1 will go in front of the metal partition on grate (see Figure 18). Make sure notches in bottom of log fit over grate.

2.Place log #2 (large front log) over pins on grate (see Figure 19).

3.Place log #3 (c-shaped crossover log) onto rear and front logs as shown in Figure 20. Make sure it is seated properly on the smooth surface on front log and on the pin on back log.

4.Place log #4 (small round log) on pin on right side of front log (see Figure 21).

CD32M
Log #1	1
Placement

Figure 18 - Installing Log #1 (CD36M-A Series Shown)

2

Figure 19 - Installing Log #2 (CD36M-A Series Shown)

3

Figure 20 - Installing Log #3 (CD36M-A Series Shown)

4

Figure 21 - Installing Log #4 (CD36M-A Series Shown)

111916-01F www.desatech.com 11