Desa CD42M-A2, CD32M-2, CD36M-A1, CD36M-A2 Introduction, Selecting Location, Before YOU Begin

INTRODUCTION

WARNING: This product con- tainsand/orgenerateschemicals known to the State of California to cause cancer or birth defects or other reproductive harm.

Models CD32M series, CD36M-A series and CD42M-A series are heat circulating grav- ity direct-vent fireplaces with sealed combustion chamber. These fireplaces use millivolt gas control valve and millivolt ignition system.

These fireplaces are convertible with the standard setup as natural gas. Conversion may be performed by the O.E.M. mobile home builder or by a quali- fied service person on-site. If you are uncertain as to what gas your unit is equipped for, please check the rating plate located inside of the appliance opening or consult your mobile home supplier or your local distributor of DESA/Vexar products.

NOTICE: Check local building codes for area requirements be- fore installing this appliance.

BEFORE YOU BEGIN

Before beginning the installation of your appli- ance, read these instructions through completely.

This DESA/Vexar fireplace and its components are safe when installed according to this installation manual and operated as recommended. Unless you use DESA/Vexar components designed and tested for this fireplace system, YOU MAY CAUSE

A SAFETY HAZARD!

The DESA/Vexar warranty will be voided by, and DESA/Vexar disclaims any responsibility for the following actions:

A)Modification to the fireplace, components, doors, blower, fans or vent system.

B)Use of any component part not manufactured or approved by DESA/Vexar in combination with a DESA/Vexar fireplace system.

Proper installation is the most important step in ensuring safe and continuous operation of the fireplace. Consult the local building codes as to the particular requirements concerned with the instal- lation of all factory built fireplaces. This fireplace, when installed, must be electrically grounded in accordance with local codes or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70 or the Canadian Electrical Code, CSA C22.1.

The installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1 or the Canadian Installa- tion Code, CAN/CGA B149. This appliance com- plies with ANSI Z21.88-1998 and CSA 2.33-M98 as a VENTED GAS FIREPLACE HEATER.

SELECTING LOCATION

To determine the safest and most efficient loca- tion for your fireplace, consider the following guidelines:

1.The location must allow for proper clearances (see Figure 1).

2.Consider a location where the fireplace would not be affected by drafts, air conditioning ducts, windows or doors.

3.Alocation that avoids the cutting of joists or roof rafters makes ventilation installation easier.

In selecting a location, the following precautions must be observed:

•Do not connect this appliance to a chimney system used for solid fuel burning fireplace.

•Due to high temperatures, do not locate this appliance in high traffic areas or near furniture and draperies.

•Never obstruct the openings of the appliance or flow of ventilation air. Keep the control compartments accessible.

FULL

PROJECTION CORNER

INSTALLATION

FLUSH

INSTALLATION

Flush installation is recommended where living space is limited.

Projected installation may be ideal for a new addition to an existing finished wall.

Corner installation makes use of a space that may not normally be used and provides a wider and more efficient range for radiant heat transfer.

Figure 1 - Common Fireplace Locations

111916-01F www.desatech.com 3