Desa VGMRN, CGMFN, CGMFP, VGMRP installation manual Table of Contents

Page 2

TABLE OF CONTENTS

Safety Information

2

Inspecting Burners

24

Local Codes

4

Cleaning and Maintenance

24

Unpacking

4

Troubleshooting

25

Product Identification

5

Specifications

29

Product Features

5

Wiring Diagram

29

Optional Remote Control Accessories

5

Service Hints

29

Assembly

5

Technical Service

29

Air for Combustion and Ventilation

6

Replacement Parts

29

Installation

9

Illustrated Parts Breakdown and Parts List

30

Operating Fireplace

18

Accessories

34

Inspecting Burners

23

 

 

Safety Information

WARNING: Improper in- stallation, adjustment, al- teration, service or main- tenance can cause in- jury or property damage. Refer to this manual for correct installation and operational procedures. For assistance or addi- tional information con- sult a qualified installer, service agency or the gas supplier.

WARNING: This is an unvented gas-fired heat- er. It uses air (oxygen) from the room in which it is installed. Provisions for adequate combustion and ventilation air must be provided. Refer to Air for Combustion and Ven- tilation section on page 6 of this manual.

This appliance may be in- stalled in an aftermarket,* permanently located, manufactured (mobile) home, where not prohib- ited by local codes.

This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases.

*Aftermarket: Completion of sale, not for purpose of resale, from the manufacturer

WARNING: This product con- tainsand/orgenerateschemicals known to the State of California to cause cancer or birth defects or other reproductive harm.

IMPORTANT: Read this owner’s manual carefully and completely before trying to assemble, op- erate or service this fireplace. Improper use of this fireplace can cause serious injury or death from burns, fire, explo- sion,electricalshockandcarbon monoxide poisoning.



www.desatech.com

119315-01A

Image 2
Contents OWNER’S Operation and Installation Manual Shown with Optional Cabinet Mantel/Hearth Base AccessoryTable of Contents Safety Information Local Codes UnpackingAssembly Product FeaturesOptional Remote Control Accessories Product IdentificationAir for Combustion Ventilation Providing Adequate VentilationConfined and Unconfined Space AIR for Combustion VentilationDetermining FRESH-AIR Flow for Fireplace Location Determining if You Have a Confined or Unconfined SpaceVentilation Air From Outdoors Ventilation AIRVentilation Air From Inside Building Check GAS Type InstallationInstallation Items Fireplace Clearances InstallationBuilt-In Fireplace Installation Fireplace pilot and burner must be at least 18 above floorMantel Clearances for Built-In Installation If you have not assembled firebox, follow instructions onRoute flexible gas line through access hole in hearth base Placing Hearth Base Against WallConnecting to GAS Supply Propane/LP Supply Tank External RegulatorPropane/LP Connecting Fireplace to Gas SupplyInstallation Items Needed NaturalCorrect all leaks at once Checking GAS ConnectionsTest Pressures Equal To or Less Than Psig 3.5 kPa Installing Receiver Optional Wireless hand-held Remote Control AccessoriesPressure Testing Fireplace Gas Connections Installing 9-Volt Battery in Hand-Held Remote Control UnitMust not be lengthened See FigureAs pictured in Figure Air conditioning ductsFor Your Safety Read Before Lighting Optional Wall Switch GWMS2 Remote-Ready Models OnlyInstalling LOG SET and Screen Operating FireplaceOperating Fireplace Lighting InstructionsRemote-ready Models Manual Lighting ProcedureTo Turn OFF GAS To Appliance Shutting Off FireplaceOptional Hand-Held Remote OperationOn/Off Series Model HRC100 and HRC101 Manual ModeAuto Thermostatic Mode Thermostat Series Model HRC200 and HRC201Pilot Flame Pattern Switch OptionalInspecting Burners Burner Flame PatternIf burner flame pattern is incorrect, as shown in Figure Cleaning MaintenanceBurner Injector Holder Pilot Air Inlet Hole Blow air into the primary air holes on the injector holderLOG Set TroubleshootingObserved Problem Possible Cause Remedy CabinetTroubleshooting Observe minimum installa Delayed ignition of burnerNoise when burner is lit White powder residue forming When heated, vapors fromGas leak. See Warning Replacement Parts SpecificationsWiring Diagram Service HintsIllustrated Parts Breakdown MANUAL-controlled models Cgmfn and CgmfpParts List 101629-02Illustrated Parts Breakdown REMOTE-READY Models Receiver and HAND-HELD Remote Control KIT HRC100 and HRC101 AccessoriesWALL-MOUNT ON/OFF Switch Equipment Shutoff Valve GA5010119315-01A Not a UPC

VGMRN, VGMRP, CGMFN, CGMFP specifications

Desa CGMFP, VGMRN, VGMRP, and CGMFN represent a series of cutting-edge developments designed to optimize various aspects of modern technology and infrastructure. These entities focus on enhancing efficiency, sustainability, and overall performance within their respective domains.

Desa CGMFP, or the Comprehensive Green Manufacturing Facility Program, is dedicated to promoting sustainable manufacturing practices. Its primary features involve the integration of green technologies that minimize waste and energy consumption. The program emphasizes the use of renewable energy sources, such as solar and wind, to power manufacturing operations. This initiative not only reduces the carbon footprint of production processes but also helps organizations meet regulatory standards for environmental protection.

VGMRN, which stands for Variable Grid Management and Resource Network, is a sophisticated system designed to enhance the efficiency of energy distribution. It utilizes advanced algorithms and machine learning to manage energy loads dynamically across the grid. One of the standout characteristics of VGMRN is its ability to forecast energy demand patterns, allowing for proactive adjustments to energy supply. This results in minimized downtime and optimized usage of resources, making it an essential component of smart grid solutions.

VGMRP, or Variable Grid Management and Resource Planning, complements the work of VGMRN by focusing on the strategic planning of resource allocation within energy networks. Its core features include predictive analytics and scenario modeling, which empower utilities to simulate various energy distribution scenarios and make informed decisions. This technological approach not only aids in efficient resource use but also supports resilience against fluctuations in energy supply and demand.

Lastly, CGMFN, the Comprehensive Green Manufacturing Framework Network, provides a robust platform for collaboration across industries engaged in green manufacturing. This network facilitates the sharing of best practices, research advancements, and innovative solutions. Key characteristics of CGMFN include a strong emphasis on interdisciplinary cooperation and the promotion of circular economy principles, which encourage the utilization of recycled materials and waste reduction strategies.

Together, these initiatives encapsulate a forward-thinking approach to manufacturing and energy management. They leverage technology and strategic planning to enhance productivity while ensuring that environmental sustainability remains at the forefront of operations. As industries continue to evolve, Desa CGMFP, VGMRN, VGMRP, and CGMFN will play pivotal roles in shaping a greener, more efficient future.