OPERATING FIREPLACE
For Your Safety Read Before Lighting Normal Lighting Instructions
23
OPERATING FIREPLACE
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing prop- erty damage, personal injury or loss of life.
A.This appliance has a pilot which lights automatically when using the supplied wall switch or remote control. If you have a power outage, the pilot may be lighted by hand with
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire de- partment.
C.Electric Power Outage Only: Use only your hand to turn the manual override handle on the gas control knob. Never use tools. If the knob will not turn by hand, don’t try to repair it, call a qualified service technician or gas supplier. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
A. Using Supplied Wall Switch Assembly
1.Set manual ignition bypass switch on the control panel to the OFF position (automatic ignition position).
2.Press ON/OFF button. Hold for 6 seconds. Gas valve will open and electronic ignition will begin sparking to light pilot. LED will light. Note: You may be running this heater for the first time after connecting to gas supply or at the start of your heating season. If so, the ON/OFF button may need to be pressed again. This will allow air to bleed from gas system. If several attempts to light pilot fail, contact a qualified service person or gas supplier for repairs. Until repairs are made, light and operate manually (see Manual Lighting Instructions for Electric Power Outage, page 24).
3.When pilot flame is lit, the thermocouple is heated by the flame. When thermocouple becomes hot (5 to 15 seconds), main burner will automatically light on high flame.
4.To lower flame, push HI/LO button on wall switch once. Note: This fireplace does not have a
CAUTION: Do not try to adjust heating levels by using the equipment shutoff valve.
|
| Manual Ignition Bypass |
|
| Switch (Up is for |
|
| Remote Control) |
| MANUAL |
|
| IGNITION | ON/OFF Button |
HI/LO |
| |
|
| |
Button | ON OFF | Wall |
HI LO | ||
|
| Switch |
| LED | Assembly |
|
|
Figure 47 - Control Locations
NORMAL LIGHTING
INSTRUCTIONS
WARNING: You must operate this heater with the fireplace screen in place. Make sure fireplace screen is in place before running heater.
Manual Ignitor
Pilot Electrode Automatic
Burner
Ignitor
Electrode
NOTICE: During initial operation of new heater, burning logs will give off a
1.STOP! Read the safety information above.
2.Make sure equipment shutoff valve is fully open.
3.Wait five (5) minutes to clear out any gas. Smell for gas around heater and near floor. If you smell gas, STOP! Fol- low “B” in the safety information on warnings plate. If you don’t smell gas, go to the next step.
Figure 48 - Pilot (Natural Gas)
Manual
Pilot Ignitor Automatic
Burner Electrode Ignitor
Electrode
Figure 49 - Pilot (Propane/LP Gas)
For more
visit www.
.com
