Vermont Castings, Majestic Products DVRT36/39/43
Remote Controls
Optional remote control units are available to control different functions of the appliance.
Model | Function(s) Controlled |
MRC1 | On/ Off |
MRC2 | On/Off and Temperature |
MRC3 | On/Off and Temperature control |
| with digital display and programmable 24- |
| hour clock |
IMT | |
|
|
| Ceramic Refractory Panels |
|
|
Ceramic refractory panels are available to line the firebox area. The ceramic lining kit for the DVRT43 is supplied standard with the appliance.
Adjustable |
| ||
Tab |
| Adjustable | |
|
| ||
|
| Tab | |
Side | Back | Side | |
Panel | Panel | ||
|
| Panel | |
| Log Support |
| |
| Burner Housing |
| |
| Assy | Floor | |
|
| ||
Floor |
| Refracotory | |
| Panel | ||
Refracotory |
| ||
Panel | Lower Side |
| |
Supports | FP1193 | ||
| |||
Fig. 60 | Install ceramic refractory panels. |
| |
| Rear Refractory |
| |
| Panel |
| |
Unit | Kit Model |
DVRT36 | CR KIT DVT36 |
DVRT39 | CR KIT DVT39 |
For installation, refer to Figures 59 and 60.
Take care when handling the refractory panels, as they are fragile until secured in place and supported.
1. | Remove the window frame assembly. |
2. | Remove the logs. |
3. | Place the lower supports for the side refractory |
| panels on the base of the firebox. Place each |
Rear Panel
Support
Brackets
Rear Log
Support
Firebox Back
FP1194
| support so that the slotted hole fits over the forward |
| screw head along the edge of the base. |
4. | Lay the angular base panels in place on the floor of |
| the firebox on either side of the burner housing |
| assembly. |
5. | Loosely attach the top adjustable tabs to the |
| studs located in the top of the firebox toward the |
| front corners. |
6. | Place the rear refractory panel in place. Locate the |
| ‘small brick’ edge of the panel into the two small |
| supports on the back panel just above the rear |
| log support. |
7. | Slide the side refractory panels into place to hold |
| the rear panel secure. Adjust the top adjustable |
| tabs to hold the side panel against the firebox wall |
| and secure the tab. Repeat the procedure on the |
| other side. |
8. | Replace the logs and window frame assembly. |
NOTE: For aesthetic purposes, aligning the horizontal mortar lines is recommended.
Fig. 61 Place the rear panel on rear support brackets.
Decorative Bay Window
When fitting the bay window kits the original front frame/glass assembly must remain in place. The bay window kit is fitted over the existing front glass.
Bay window kits are available for the DVRT36 and DVRT39 model fireplaces.
Installation
1.Remove the existing louvre assembly bottom complete with the hinges.
2.Remove the louvre assembly top.
3.Assemble the bay window kit according to the instructions supplied with the kit.
4.Place the two pieces of ceramic refractory along the base of the bay window. (Fig. 62)
5.Hang the bay window assembly over the existing window frame assembly.
6.Reinstall the upper louvre assembly.
Do not remove the existing window frame assembly.
44 | 10002428 |