Verticaltermination

Step 6. SliOe the appliance and vent assembly towards the wall, carefully insertingthe vent pipe into the vent cap assembly.lt is important that the vent pipe extend into the vent cap sufficient distance so as to resuftin a minimumpipe overlapof 1-114 inches. Secure the connectionbetween the vent pipe and the vent caP by attaching the two sheet metal strips extending from the vent cap assembly into the outer uiall of the vent pipe, siliconer'vent connection. Use the two sheet metal screws provided to connect the strips to the Pipe Section.Bend any remainingportionof the sheetmetalstrip back towards the vent cap, so it will be concealedby the decorativewall thimble cover.(Fig.9)

Step 7. Sliae the decorativewall thimble up the wall surface and attach with screws provided. Apply decorative brass or chrometrim if desired.(Fig.10)

WALL THIMELE

STRAP

Step l.Check these instatlationinstructionsfor required FtG .11

clearance (air spaces) to combustibles when

passing through ceilings, walls, roofs, ,'enclosures, attic rafters, or other nearby

combustiblesurfaces. Do not pack air spaces with insulation. Check these instructions for maximumverticalrise of the ventingsystem,and any maximumhorizontaloffset limitations.Any offset must fall within the parameters of the ventinggraph.(Fig.t)

Step 2. Setthe gas appliancein it,sdesiredlocation.Drop

aplumbbob downfrom the ceilingto the position of the applianceflue exit, and mark the location where the vent will penetratethe ceiling.Drill a small hole at this point. Next,drop a plumb bob

1 6