General Glass Information, Louvre Removal

OPERATING INSTRUCTIONS

GENERAL GLASS INFORMATION

Only glass approved for use in products may be used for replacement.

1 . The use of subsitute glass will void all product warranties.

2.Care must be taken to avoid breakage of the glass.

3.Under no circumstances should this appliance be operated without the front glass or with a broken glass. Replacement of the glass (with gasket) as supplied by the manufacturer should be done by a licenced qualified service person.

LOUVRE REMOVAL

(Fig. 40) To remove top louvre pull louvre up and then lift out.

LOUVRE 1.

GLASS

PANEL

Fig. 38

GLASS FRAME REMOVAL

1.Shut off gas.

2.Let the fireplace cool if it has been operating.

3.Remove top louvre. (See Louvre Removal)

4.Open the lower louvre assembly.

5.Release the two clamps at the bottom of the window frame by pulling down on the clamp handles.

6.Lift off the glass frame as shown.

7.To reinstall glass follow the above procedure in reverse. (Fig. 41)

GLASS

FRAME

FIREPLACE

FRONT

CLAMPS

WINDOW

FRAME

WINDOW

FRAME PULL

PUSH CLAMP HOOK

CLAMP HANDLE

Fig. 41

GLASS CLEANING

It will be necessary to clean the glass periodically. During start-up condensation, which is normal, forms on the inside of the glass and causes lint, dust and other airborne particles to cling to the glass surface. Also initial paint curing may deposit a slight film on the glass. It is therefore recommended that the glass be cleaned two or three times with a non-ammonia household cleaner and warm water (we recommend gas fireplace glass cleaner). After that the glass should be cleaned two or three times during each heating season depending on the circustances present.

Clean glass after first two weeks of operation. Do not clean glass when hot.

Do not use abrasive cleaners. Do not strike or slam the glass.

- 18 -