Final Finishing, Hearth, GAS Specifications

FINAL FINISHING

Non-combustible materials such as brick and tile can be extended over the outer face of the unit (Do not cover louvres or glass door). If a Trim Kit is going to be installed, brick and tile will have to be installed flush with the side of this appliance.

HEARTH

A hearth is not mandatory but it is recommended for aesthetic purposes. We recommend a non-combustible hearth which does not obstruct louvre opening.

Cold climate installation recommendation: When installing this unit against a non- insulated exterior wall or chase, it is mandatory that the outer walls be insulated to conform to applicable insulation codes.

GAS SPECIFICATIONS

			MAX.	MIN.
			INPUT	INPUT
MODEL	FUEL	GAS CONTROL	B.T.U.H	B.T.U.H.
DBR33 RN	Natural Gas	Millivolt Hi/Lo	15,000	10,500
DBR33 RP	Propane Gas	Millivolt Hi/Lo	15,000	11,250
DBR36 RN	Natural Gas	Millivolt Hi/Lo	18,000	12,600
DBR36 RP	Propane Gas	Millivolt Hi/Lo	18,000	13,500
DBR39 RN	Natural Gas	Millivolt Hi/Lo	22,000	15,400
DBR39 RP	Propane Gas	Millivolt Hi/Lo	22,000	16,500

				Table 6

GAS INLET & MANIFOLD PRESSURES

	NATURAL	LP (Propane)
Input Minimum	4.5" wc	11" wc
Input Maximum	7" wc	13" wc
Manifold Pressure	3.5" wc	10" wc
		Table 7

CERTIFIED TO:

ANSI Z1.88b-1999/CSA Z2.33-M-99 harmonized, standard for Vented Gas Fireplace.

Do not use this fireplace if any part of it has been under water. Immediately call a qualified service technician to inspect the fireplace and replace any part of the control which has been under water.

The installation of your Fireplace must conform with local codes, or in the absence of local codes, with National Fuel Gas Code, ANSI Z223.1 — latest edition, or CAN 1 B1-

149.1and .2 Installation Code. (EXCEPTION: Do not derate this appliance for altitude. Maintain the manifold pressure at 3.5 inches W.C. for Natural Gas and 10 inches W.C. for LP gas.)

- 6 -