Drolet 7000 MVRLC, 36C03U TYPE 139 manual Glass Front Removal Cleaning And Installation

Page 12
GLASS FRONT REMOVAL CLEANING AND INSTALLATION :

GLASS FRONT REMOVAL CLEANING AND INSTALLATION :

*To remove the glass front, unscrew the six screws holding it in place as shown.

CAUTION : Hold the glass while unscrewing to prevent it from falling.

*Clean the glass only with liquid cleaners or soaps and water, do not use abrasive cleaners which could remove the coating on the glass.

WARNING : Do not clean when hot, turn off the fireplace at least 30 minutes before removing the glass front.

*The glass used on your fireplace is a high temperature ceramic 5 mm thick with a special coating for use with gaseous fuels. Do not replace it with any other material.

CAUTION : Do not operate your fireplace without a glass or with a broken glass.

11

Image 12
Contents INSTALLATION AND OPERATING INSTRUCTIONS FOR YOUR SAFETYFIREPLACE GAS INSERT FOR YOUR SAFETYTABLE OF CONTENTS GENERAL INFORMATION KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCEDO NOT MODIFY THIS APPLIANCE SPECIFICATIONS TOP, SIDE AND FRONT VIEWS INSTALLATION 11.Secure the liner to the 4” connector on the top of the ULTRA FLAME with three metal screws WARNING DO NOT USE OPEN FLAME TO CHECK LEAKS Distance between valve 25.Install a cap on the liner GLASS FRONT REMOVAL CLEANING AND INSTALLATION BURNER REMOVAL AND INSTALLATION LOG INSTALLATION FACE PLATE ASSEMBLY AND INSTALLATION INSTALLATIONS REFRACTORY PANELS INSTALLATIONS EMBERS KIT INSTALLATIONSOPERATING INSTRUCTIONS LIGHTING INSTRUCTIONS SHUTDOWN INSTRUCTIONSFAN OPERATION MAINTENANCE INSTRUCTIONS PILOT BURNER ADJUSTMENTREPLACEMENT PARTS OPTIONAL PARTSLIMITED 5 YEARS WARRANTY