Enviro EG31-118 owner manual Brick Panel Installation

Secondary Installation

Caution: Use only the type of ember material supplied with this fireplace. Due to the irregular size of the ember material, there may be more than required. Use of other foreign materials on the burners may create dangerous conditions.

If over time, through cleaning and servicing, these embers require replacement , contact your nearest Enviro dealer.

IMPORTANT: Upon the first light up after installing logs and embers, watch for ignition to ALL burner ports. If a long delay is noted wait for the appliance to cool down:

• Open the front door of the appliance

• Carefully reposition the embers, making sure that the burner ports are not plugged or blocked.

Figure 31: Focus Log Placement Complete.

Figure 32: Focus Log Set Burning.

BRICK PANEL INSTALLATION:

Remove the glass door and the log set. Remove the burner tray by undoing the hold-down screws located in the center of the pan burner and sliding the assembly to the left, then up.

Gently pull right brick side panel inward from the bottom back. Pull towards the back then out, freeing it from the front retainer.

Caution: The pilot may damage panel. Remove left side panel in the same fashion.

To install, insert front edge of brick panel into the retainer and very gently move panel forward and out until flush against firebox side.

Figure 33: Brick Panel Installation.

21