Initial Installation
Leveling legs bracket |
Figure 15: Installation of Leveling Legs.
6.Install the leveling legs. Thread the two (2) 5” (13 cm) bolts and locknut up into the captive nuts at each end of the leveling leg bracket (refer to Figure 15).
7.Place the unit part way into the fireplace. Connect the fireplace insert’s flexible gas line to the household gas supply, using locally approved methods. Place the electric cable so it can be connected to the power supply.
8.As you push the unit into its final position in the fireplace, reinstall the vent collar plate to the stove by sliding it along the draft hood and secure with the screw. Adjust the leveling legs to ensure the unit is level.
8.The trim set for your surround panel, must be installed before installing the surround panel onto the unit.
Figure 16: Corner brackets for trim.
Figure 17: Two pieces of corner bracket.
a)Attach one side trim to the top trim using a corner bracket (see Figure 16) to secure pieces together. There are two
(2) main pieces to each corner bracket (see Figure 17). When installing the corner pieces into the trim the “B FACE” sides must face each other and the screw heads are to face out. With the bracket in place and the top and a side trim snug together use a flat head screwdriver to turn the two (2) screws in the bracket in to tighten it into the trim.
b)Slide the two (2) attached trim pieces onto the surround panel.
c)Attach the other side trim piece to the top trim using the same method used in Step a.
d)Place the second side of the trim on the surround panel in the same manner use on the first side and secure in the same manner.
e)On the side trims there are holes 2” (50 mm) from either end. Using a Phillips screwdriver to place a #8 screw 11⁄4” long in each hole and tighten (refer to Figure 18). This will keep the trim tight against the surround.
NOTE: The notch at the bottom of the left trim is so the power cord can be run to the outside of the
panel.Figure 18: Screw to hold the trim against the surround.
14