SECTION
Removing/Installing the Seat Assembly
WARNING
DO NOT store items under seat - interference with seat latch may result.
NOTE: For this procedure, refer to FIGURE 7.4.
Removing
1.Disconnect the joystick. Refer to Disconnecting/Connecting the Joysticks on page 42.
2.Push down on the latch bar underneath front of seat.
3.Tilt front edge of seat up.
4.Slide the seat assembly forward to disengage seat from the pivot brackets located in the rear.
Installing
1.Position the seat in the rear pivot brackets as shown in FIGURE 7.4.
2.Tilt front edge of seat down.
3.When seat is lowered, engage seat brackets into seat clevis pins.
WARNING
When reinstalling the seat verify that the seat brackets are engaged with the seat clevis pins by pulling up on the latch bar.
4.Pull up on latch bar to verify that brackets are engaged with seat clevis pins.
5.Connect the joystick. Refer to Disconnecting/Connecting the Joysticks on page 42.
NOTE: Van Seat model 
shown. ASBA seat removes/ installs in the same way.
FIGURE 7.4
Rear Pivot
Brackets
Seat Clevis Pins
Latch Bar (located under the front of the seat)
Removing/Installing the Seat Assembly
Pronto® M94™ | 50 | Part No. 1122145 |
