SECTION
Adjusting Forks
NOTE: For this procedure, refer to FIGURE 10.4.
1.Remove the dust cover.
2.To properly tighten caster journal system and guard against flutter, perform the following check:
A.Tip back the wheelchair.
B.Pivot both forks and casters to top of their arc simultaneously.
C.Let casters drop to bottom of arc (wheels should swing once to
D.Adjust locknuts according to freedom of caster swing.
3.Test wheelchair for maneuverability.
4.Readjust locknuts if necessary, and repeat STEPS
5.Snap dust cover into the caster headtube ensuring that the tabs are under the plastic side shrouds.
NOTE: Components exploded for clarity. There is no need to remove the fork from the base frame.
Base Frame
Side Shroud
Fork
Tabs
Dust Cover
Locknut
Washer
Caster Headtube
FIGURE 10.4 Adjusting Forks
Pronto® M94™ | 68 | Part No. 1122145 |