Invacare Pronto M71 manual Adjusting the Seat Height

SECTION 7—SEAT

Adjusting the Seat Height

NOTE: For this procedure, refer to FIGURE 7.5 on page 52.

NOTE: The seat can be adjusted to five height positions in ½-inch increments.

1.Remove the seat. Refer to Removing/Installing the Seat Assembly on page 50.

2.Remove the mounting screw and locknut that secures the adjustable height tube to the support tube.

3.Adjust tube to desired mounting position. Refer to the following table for available mounting positions.

AVAILABLE MOUNTING HOLES FOR

FRONT ADJUSTABLE HEIGHT TUBE

CHAIR IS EQUIPPED WITH	A	B	C	D	E
VAN SEAT WITH FOOTBOARD
REAR ADJUSTABLE HEIGHT TUBE
Mounted in hole A	N/A**	￿	￿	￿	￿
Mounted in hole B	N/A*	N/A*	￿	￿	￿
Mounted in hole C	N/A*	N/A*	￿	￿	￿
Mounted in hole D	N/A*	N/A*	N/A*	￿	￿
Mounted in hole E	N/A*	N/A*	N/A*	N/A*	￿

*NOTE: This mounting hole combination would result in a forward seat dump. Forward seat dump is where the rear of the seat is higher than the front of the seat. The seat should never be adjusted to a position that results in a forward seat dump.

**NOTE: This mounting hole combination cannot be used because it would cause the front riggings of the wheelchair to interfere with other components of the chair.

4.Reinstall mounting screw and locknut (FIGURE 7.5). Securely tighten.

5.Repeat STEPS 2-4 for the three remaining adjustable height tubes.

WARNING

When reinstalling the seat verify that the seat brackets are engaged with the seat clevis pins by pulling up on the latch bar.

6.Reinstall the seat. Refer to Removing/Installing the Seat Assembly on page 50.

Part No. 1122145 51 Pronto® M94™