SECTION
Removing
1.Push the front rigging release lever inward and rotate the footrest out.
2.Lift up on front rigging and remove from the wheelchair.
3.Repeat STEPS
Adjusting Footrest Height
Model PHWH93
NOTE: For this procedure, refer to FIGURE 9.2.
1. Remove any accessories from the footrest(s).
2. Remove the footrest from the |
| Footrest |
wheelchair. Refer to Installing/ | Locknut | Support |
Removing Front Riggings on page 59. |
|
|
NOTE: Lay footrest on a flat surface to simplify section.
3.Remove the hex bolt, coved washers and locknut that secure the lower footrest to the footrest support.
4.Reposition the lower footrest to the desired height.
5.Reinstall hex bolt, coved washers and locknut that secure lower footrest to footrest support. Tighten securely.
Coved Washer
Hex Bolt
Coved
Washer
Lower
Footrest
FIGURE 9.2 Adjusting Footrest Height -
Model PHWH93
6.Repeat STEPS
7.Reinstall the footrest(s) onto the wheelchair. Refer to Installing/Removing Front Riggings on page 59.
8.Reinstall any accessories onto the footrest(s).
Model PH904A and PHAL4A
NOTE: PH904A style front rigging shown. PHAL4A front rigging adjust the same way.
NOTE: For this procedure, refer to FIGURE 9.3.
1.Loosen, but DO NOT remove the lug bolt and locknut that secure the lower footrest to the footrest support.
2.Reposition the lower footrest to the desired height.
Footrest
Support
Lug Bolt | Locknut |
|
Lower
Footrest
FIGURE 9.3 Adjusting Footrest Height -
Model PH904A and PHAL4A
Pronto® M94™ | 60 | Part No. 1122145 |