Invacare Pronto M71 manual Engaging/Disengaging Motor Release Lever, Top Shroud, Base Frame

SECTION 10—SHROUD/WHEELS

DETAIL “A” - TOP SHROUD

DETAIL “B” - FRONT SHROUD

Top Shroud

Rear of Seat Supports

Wheelchair

Base Frame

Hook and	Front of
	Wheelchair
Loop Strips

Base Frame

Hooks

Release

Knob

Front

Shroud

FIGURE 10.1 Removing/Installing the Shrouds

Engaging/Disengaging Motor Release Lever

WARNING

DO NOT engage or disengage the motor release lever until the On/Off switch on the joystick is in the Off position.

CAUTION

Ensure both motor release levers are fully engaged before driving the wheelchair

NOTE: The motor lock disengagement/engagement allows freewheeling or joystick controlled operation. Freewheeling allows an attendant to maneuver the wheelchair without power.

NOTE: For this procedure, refer to FIGURE 10.2 on page 67.

1.Locate the motor release handles on the motors protruding through the shrouds by the rear springs.

2.Perform one of the following:

• To Disengage the motor release levers -

NOTE: This allows the chair to freewheel for pushing if necessary

i.Slide the motor lock lever towards the outside of the wheelchair (free wheel position) as shown in Detail “A” of FIGURE 10.2.

•To Engage the motor release levers -

NOTE: This allows the motors to drive the wheels.

i.Slide the motor lock handles towards the center of the wheelchair (drive position) as shown in Detail “A” of FIGURE 10.2.

Pronto® M94™ 66 Part No. 1122145