Invacare Pronto M71 manual Arms, Installing/Removing Flip Back Armrests

SECTION 6—ARMS

SECTION 6—ARMS

WARNING

After ANY adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.

Before performing any maintenance, adjustment or service verify that On/Off switch on the joystick is in the Off position.

Installing/Removing Flip Back Armrests

WARNING

Make sure the flip back armrest release and height adjustment levers are in the locked position before using the wheelchair.

NOTE: Flip back armrest release lever must be in unlocked position when placing armrest into the arm sockets.

NOTE: For this procedure, refer to FIGURE 6.1 on page 45.

Installing

1.Slide the flip back armrest into the arm sockets on the wheelchair frame.

2.Install the quick release pin through the rear arm socket and flip back armrest.

3.Lock flip back armrest by pressing flip back armrest release lever into the locked position (FIGURE 6.1).

4.Lift up on flip back armrest to make sure the armrest is locked in place.

5.Repeat STEPS 1-4 for opposite flip back armrest.

Removing

1.Unlock flip back armrest by pulling flip back armrest release lever into the unlocked position (FIGURE 6.1).

2.Remove the quick release pin that secures the flip back armrest to the wheelchair frame.

3.Pull Up on the flip back armrest and remove the armrest from the arm sockets.

4.Repeat STEPS 1-3 for the opposite flip back armrest, if necessary.

Pronto® M94™ 44 Part No. 1122145