SECTION
Motor
Release
Lever
DETAIL “A”
Towards Center
of Wheelchair
Towards Outside
of Wheelchair
Motor Locks
Disengaged
(Freewheel Mode)
Motor Locks Engaged
(Drive Mode)
FIGURE 10.2 Engaging/Disengaging Motor Release Lever
Replacing Front/Rear Caster Assemblies
NOTE: For this procedure, refer to FIGURE 10.3.
NOTE: Front and rear caster assemblies are replaced in the same manner.
NOTE: When replacing the front/rear caster assemblies, it is necessary to brace the caster assemblies to prevent the wheel from spinning.
1.Remove the mounting screw, two washers, and locknut that secures the caster to the fork.
2.Remove the caster and discard.
3.Secure new caster to fork with existing mounting screw, two washers and locknut (FIGURE 10.3). Securely tighten.
Locknut
Mounting
Screw
Washer
Washer
Caster
FIGURE 10.3 Replacing Front/Rear Caster Assemblies
Part No. 1122145 | 67 | Pronto® M94™ |