Invacare Pronto M71 manual Adjustable Seat Back Angle ASBA Model

SECTION 7—SEAT

Adjustable Seat Back Angle (ASBA) Model

NOTE: For this procedure, refer to FIGURE 7.3.

1.Remove armrests from the wheelchair. Refer to Installing/Removing Flip Back Armrests on page 44.

2.Remove the mounting screw and washer from the top mounting hole of back angle plate and back cane.

NOTE: To avoid losing the insert in each back cane, thread the mounting screw through the cane from the inside of wheelchair to hold the insert in place.

3.Remove the mounting screw and washer from the bottom mounting hole of the back angle plate and back cane.

4.Reposition the back canes into the correct mounting holes of the back angle plate to obtain a back angle between 80° and 100° in 5° increments.

5.Torque mounting screws to 75 inch-pounds.

6.Reinstall the armrests onto the wheelchair. Refer to Installing/Removing Flip Back Armrests on page 44.

	80°	85°
Top	Top Rear	Top
		Top Rear
Bottom	Bottom	Bottom
	Front	Bottom
		Front

90°	95°
Top	Top
Top Rear
	Top Rear
Bottom
Bottom	Bottom
Front	Bottom
	Front

100°

Top
	Top Rear
Bottom	Bottom
	Front

FIGURE 7.3 Adjusting the Back Angle - Adjustable Seat Back Angle (ASBA) Model

Part No. 1122145 49 Pronto® M94™