Initial Installation
QUALIFIED INSTALLERS ONLY
10. Connect the wires from the unit to the ON/OFF/ THERMOSTAT switch and the FAN CONTROLLER (see
INITIAL INSTALLATION - ELECTRICAL REQUIREMENTS).
11. Place the assembled surround panel around the stove, align the slots. Push back then down to engage the surround panel hooks with the slots in the fireplace. Install the decorative fascia or bay window options to the appliance by aligning the hooks and the slots in the fireplace as seen in the surround panel installation.
| Figure 19: Surround Panel installation. | |
FAN CONTROLLER & BURNER SWITCH INSTALLATION: |
| |
The fan controller and burner switch may be installed in one of three places. Keep the wires away from | ||
the bottom of the firebox or any other hot surfaces. |
| |
Option 1 - Unit Panel, Cast Iron Faceplate, Bay Door |
| |
Assembly, or Custom Surround Panel. |
| |
The fan controller and burner switch are to be installed | A | |
into the Focus’ control panel (see Figure 20). Remove the |
| |
knob and screw from the fan controller and place the fan |
| |
controller through the round hole in the control panel from | Wiring harness | |
the back. Tighten nut onto fan controller from the front of |
| |
control panel and push on the knob. The burner switch is | Fan controller location | |
just pushed into place from the front of the control panel. | ||
| ||
Route the wiring harness as shown in Figure 20. | Burner switch location | |
Option 2 - Standard Surround Panel. |
|
Figure 20: Component placement. |
The standard surround panel comes with a fan controller and burner switch so the set that comes with the unit panel can be kept as spare parts. The fan controller comes
Option 3 - Cast Iron Faceplate or Bay Door Assembly.
The fan controller is to be installed into the Focus’ control panel but the burner switch can be installed into the fascia (see Figure 20). To accomplish this, cut one wire tie so that the wires can be properly routed. Place the orange and white wires through through the hole in the side of the unit, marked with an “A” in Figure 20, then along behind the front edge of the fireplace bottom to the control panel. Use the wire ties provide to bundle and secure wire. Remove the knob and screw from the fan controller and place the fan controller through the round hole in the control panel from the back. Tighten nut onto fan controller from the front of control panel and push on the knob. The burner switch is pressed into a
notch on the edge of the fascia.
15