INSTALLATION
OPTIONAL REMOTE
CONTROL
Use the Waterford Remote Control Kit approved for this unit. Use of other systems may void your warranty.
The remote control kit comes with a hand held transmitter, a receiver and a wall mounting plate.
1)Choose a convenient location on the wall to install the receiver and the receptacle box (protection from extreme heat is very im- portant). Run wires from the fireplace to that location, use Thermostat Wire Table.
2)Connect the wires as per the wiring dia- gram below.
CAUTION
Do not connect the millivolt remote control wires to the 120V wires.
3)Install 3 AAA alkaline batteries in transmit- ter and 4 AA alkaline batteries in the receiver. Install the receiver and its cover in the wall. Switch the remote receiver to "remote" mode. The remote control is now ready for operation.
This heater does not require a 120V A.C. supply for operation. In case of a power failure, the burner switch and the optional remote control/thermostat will continue to operate. However, a 120V A.C. power supply is needed for the fan/blower operation.
WIRING DIAGRAM
Caution: Ensure that the wires do not touch any hot surfaces and are away from sharp edges.
Verify proper operation after serv- icing.
If any of the original wires as supplied with the appliance must be replaced, it must be replaced with CSA type SEW (200oC) or its equivalent.
WARNING: Electrical Grounding Instructions
This appliance is equipped with a three pronged (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded three- prong receptacle. Do not cut or remove the grounding prong from this plug.
CAUTION: Label all wires prior to dis- connection when servicing controls. Wiring errors can cause improper and dangerous operation.
14 | Waterford E61 Gas Fireplace Insert |