Waterford Appliances E61-LP, E61-NG Conversion KIT From Natural GAS to Propane Model #260-960

Page 9

INSTALLATION

Part # Description

948-305 3" Flex - 35 ft.

946-529 Co-linear DV Vertical Termination Cap

Alternate Approved Caps

980

Vertical Termination Cap

991

High Wind Cap

923GK

3" Co-linear Adaptor with flashing

In areas on consistently high winds, we recom- mend using the Simpson Dura-Vent System (923GK adapter and 991 high-wind cap).

The Air Intake pipe must be attached to the inlet air collar of the termination cap.

5)Install flashing.

6)Insert both liners into chimney, passing through the damper opening.

7)Install termination cap.

8)Connect the marked end of the liner to the inlet collar of the vent connector plate marked with an "I", seal connection with high temperature silicone. Secure with gear clamp.

9)Connect the 2nd liner to the exhaust collar marked with an "E", seal connection with high temperature silicone. Secure with

gear clamp.

nections of liner to inlet and vent col- lars.

10)Attach the top shield to the top front lip of the firebox using 3 screws.

CONVERSION KIT

FROM NATURAL GAS TO PROPANE MODEL #260-960

for Emerald E61 Gas Insert

using SIT 820 NOVA Gas Valve

FLUE LINER

INSTALLATION

1)Cut the flex liner as required.

2)Mark the end of one liner to indicate Inlet.

3)Connect the other end of the above liner to the inlet side of the termination adaptor, seal connection with high temperature silicone. Secure with gear clamp.

4)Connect the 2nd liner to the exhaust side of the adaptor, seal connection with high tem- perature silicone. Secure with gear clamp.

NOTE:

1)Final gas connection should be made after unit is in place to avoid damage to line when pushing the unit into position.

2)Mill-pac may be used instead of high temperature silicone and screws may be used instead of gear clamps at con-

THIS CONVERSION MUST BE

DONE BY A QUALIFIED

GAS FITTER

IF IN DOUBT DO NOT DO THIS

CONVERSION!!

Conversion Kit Contains:

Qty.Part #

Description

1910-018 SIT Conversion Kit-50% Turndown LP

1910-383 LP Injector (Pilot Orifice)

1904-641 Burner Orifice #50

1908-455 Decal "Converted to Propane"

1908-528 Red "PROPANE" label

1908-173 Instruction Sheet

1)Shut off the gas supply.

2)Open the lower grill and remove the 2 screws holding the control panel in place.

Remove the 2 screws holding the

Control Panel in place.

Waterford E61 Gas Fireplace Insert

9

Image 9
Contents Models E61-NG Natural Gas E61-LP Propane Emerald Gas Fireplace InsertWaterford E61 Gas Fireplace Insert Waterford GAS Fireplace InsertTable of Contents Duplicate Serial no Safety LabelCertified for/Certifiée pour Canada and U.S.A Installation Materials Required Clearances to CombustiblesFloor Protection GAS Connection High ElevationVenting Flue Liner Installation For Emerald E61 Gas Insert Using SIT 820 Nova Gas ValveConversion KIT From Natural GAS to Propane Model #260-960 New screws E supplied with the kit. Tighten screws securely Pilot assembly is now accessible for Steps 6 toNatural Gas Kit # Propane Kit # GAS Pipe Pressure TestingAeration Adjustment Shroud InstallationValve Description Diagram 1 Do not force logs down LOG InstallationDiagram Optional Door GrillOptional Remote Control Wiring DiagramVerify proper operation after serv- icing Operating Instructions Copy Lighting Plate Instructions Maintenance InstructionsGas Control Valve Unit Body/FireboxLOG Replacement Cleaning MaintenanceGlass Replacement FAN MaintenanceValve Maintenance Thermodisc access is through the Fan Access PanelTo remove fan Replacement / Spare Parts List Parts ListDescription Parts List Waterford E61 Gas Fireplace Insert Conditions WarrantyRegister your Waterford online at