Maintenance, LOG Replacement Cleaning | Waterford Appliances E61-LP

WARNING: CHILDREN AND ADULTS SHOULD BE ALERTED TO THE HAZARDS OF HIGH SUR- FACE TEMPERATURE AND SHOULD STAY AWAY TO AVOID BURNS OR CLOTHING IGNITION. YOUNG CHILDREN SHOULD BE CAREFULLYSUPERVISEDWHEN THEYAREINTHESAMEROOMAS THE APPLIANCE.

CLOTHING OR OTHER FLAMMA- BLE MATERIAL SHOULD NOT BE PLACEDONORNEARTHEAPPLI- ANCE.

7) Each time the appliance is lit, it may cause condensation and fog the glass. This con- densation and fog is normal and will disap- pear in a few minutes as the glass heats up.

MAINTENANCE

LOG REPLACEMENT &

CLEANING

The unit should never be used with broken logs. Turn off the gas valve and allow the unit to cool before opening door to carefully remove the logs. The pilot light generates enough heat to burn someone. If for any reason a log should need replacement, you must use the proper replacement log. The position of these logs must be as shown in the diagram under Log Installa- tion.

NOTE: Improper positioning of logs may create carbon build-up and will alter the unit’s perform- ance which is not covered under warranty.

Cleaning the Log Set and Firebox

2)a) Remove the 7 nuts that secure the front glass bracket holding the center glass in place.

b)If removing the side glass, remove the 2 nuts that secure the retainers holding each side glass in place.

Never operate the appliance without	During the annual inspection and maintenance
the glass properly secured in place or	appointment, the service person should clean
with the door open.	dust, lint, and any light accumulation from the
	logs and firebox area. An extra-soft brush
8) Periodically check the pilot flames. Correct	should be use don the logs as they are extreme-
flame pattern has three strong blue flames:	ly fragile; a vacuum cleaner may be used on the
1 flowing around the thermopile and 1	firebox. See the log installation instructions for
around the thermocouple, and 1 flowing	details on removing and replacing the logs.
across the rear of the burner (it does not
have to be touching the burner).	DOOR AND GLASS
	DOOR AND GLASS
	GASKET

Remove the 7 nuts holding the

Front Glass Bracket to the front face. CAUTION: Don't let the glass drop.

Top View of pilot flame

Incorrect flame pattern will have small, probably yellow flames, not coming into proper contact with the rear of the burner or thermopile.

Top View of pilot flame

Note: If you have an incorrect flame pat- tern, contact your Waterford deal- er for further instructions.

If the door gasket requires replacement use only the proper replacement gasket available from your Waterford dealer.

GLASS REPLACEMENT

Your Waterford stove is supplied with high temperature, 5 mm Neoceram ceramic glass that will withstand the highest heat that your unit will produce. In the event that you break your glass by impact, purchase your replacement from an authorized Waterford dealer only, and follow our step-by-step instructions for re- placement.

1)Remove the door by lifting it slightly up and off the front face.

3)Remove the glass and replace with the new glass.

4)Install the front glass bracket and turn the nuts just enough to support the glass. Tight- en the nuts alternately. Avoid overtighten- ing the nuts as this may damage the glass.

FAN MAINTENANCE

If your fan requires maintenance or replace- ment, access to the fan is through the plate on the rear wall of the firebox. NOTE: the unit

MUST NOT be operated without the fan access panel securely in place and cor- rectly sealed.

IMPORTANT: These fans collect a lot of dust from within your home. Ensure you maintain these fan mo- tors on a regular basis by vacuum- ing out the fan squirrel cages, around the motor, and around the grills on the back of the stove.

Waterford E61 Gas Fireplace Insert