4
For the State of Massachusetts, the appli- ances individual manual | For the State of Massachusetts, flexible connectors shall not exceed 36 inches in length. | For the State of Massachusetts, installation and repair must be done by a plumber or gasfitter licensed in the Commonwealth of Massachusetts. |
|
|
|
DUPLICATE SERIAL NO.
NOTE: Waterford units are constantly being improved. Check the label on the unit and if there is a difference, the label on the unit is the correct one. | This is a copy of the label that accompanies each Waterford |
205
SAFETY LABEL
Listed: VENT GAS FIREPLACE HEATER
Certified for/Certifiée pour: CANADA and U.S.A.
Report No.
Tested to: ANSI
FACTORY EQUIPPED FOR NATURAL GAS Model:E61NG ÉQUIPÉ A L'UISINE POUR GAZ NATURAL
DO NOT REMOVE OR COVER THIS LABEL /
NE PAS ENLEVER CETTE ÉTIQUETTE
Serial no./ | 205 | |
No de serie | ||
|
This appliance must be installed in accordance with local codes, if any; if none, follow the National Fuel
Minimum supply pressure | 5" WC/C.E. (1.25 kPa) |
Manifold pressure High | 3.8" WC/C.E. (0.94 kPa) |
Manifold pressure Low | 1.1" WC/C.E. (0.27 kPa) |
Factory Equipped for Altitude 0-2000 ft.
Maximum Input | 38,000 | Btu/h (11.14 Kw/h) | |
Minimum Input | 19,000 | Btu/h (5.57 Kw/h) | |
Orifice size | #32 DMS | (2.9mm) | |
Altitude | |||
Pression d'allimentation minimum
Pression à la tubulure d'échappement élevée Pression à la tubulure d'échappement basse
Débit Calorifique maximum
Débit Calorifique minimum
Dimensions de l'orifice
L'altitude
Gas Code, ANSI Z223.1/NFPA 54, or Natural Gas and
Propane Installation Codes, CSA B149.1.
FOR USE WITH GLASS DOORS CERTIFIED
WITH APPLIANCE ONLY.
This vented gas fireplace heater is
not for use with air filters. Not for use with solid fuel.
Electrical Supply (115 V, 1.13A, 60 Hz)
Approved for use with Emerald Zero Clearance Kit, Part No.
Waterford E61 Gas
Convertible for Altitude 2000-4500 ft.
Maximum Input | 36,100 | Btu/h (10.57 Kw/h) | Débit Calorifique maximum | |
Minimum Input | 18,000 | Btu/h (5.28 Kw/h) | Débit Calorifique minimum | |
Orifice size | #33 DMS | (2.87mm) | Dimensions de l'orifice | |
Altitude | L'altitude | |||
Convertible to 27,000 Btu for Altitude 0 - 4500 ft. with Kit #: | ||||
Maximum Input | 27,000 Btu/h (7.91 Kw/h) | Débit Calorifique maximum | ||
Minimum Input | 13,500 Btu/h (3.95 Kw/h) | Débit Calorifique minimum | ||
Orifice size | #40 DMS | (2.49mm) | Dimensions de l'orifice | |
Altitude | L'altitude | |||
B
A
Minimum Clearances
to Combustibles/
Degagement Minimum
De Materiaux Combustibles
Unit to Sidewalls | A 9"/230mm |
Top of Hob to mantel: | |
unshielded | B 16"/406mm |
shielded | B 12"/305mm |
To ceiling from top of stove: 36"/ 915mm
Fireplace Insert
This appliance is only for use with the type of gas indicated on the rating plate and may be installed in an aftermarket, permanenlty located,manufactured (mobile) home where not prohibited by local codes. See owner's manual for details. This appliance is not convertible for use with other gases, unless a certified kit is used.
Made in Canada/Fabrique au Canada | FPI Fireplace Products International Ltd., Delta, BC, Canada |
Floor Protector
A floor protector consisting of one layer of ½" thick WonderBoard
, Durock
, or equivalent extending at least 9" in front of the face of the unit and the full width of the front surface is required.