INSTALLATION
BRICK INSTALLATION | DOOR HANDLE |
Pedestal Ash Drawer Kit (850-100)
Firebrick is included to extend the life of your stove and radiate heat more evenly. Check to see that all firebricks are in their correct posi- tions and have not become misaligned during shipping.
The "AD" brick in the drawings above is the brick covering the Ash Dump hole that is used when the Ash Drawer Kit is installed. See page 17 for more information.
Freestanding - Small F1100
Attach spring handle by rotating counter clock- wise onto rod. Ensure that the rod fits into the entire length of the spring handle. See Diagram below.
GLASS INSTALLATION
Your Regency stove is supplied with 5 mm Neoceram ceramic glass that will withstand the highest heat that your unit will produce. In the event that you break your glass by impact, purchase your replacement from an authorized Regency dealer only.
Remove the door from the stove and remove the glass retainer. Position the glass in the door, make sure that the glass gasketing will properly seal your unit, and replace the retainer, it should rest on the gasket not the glass. Tighten secure- ly, but do not wrench down on the glass as this may cause the glass to break.
1)Remove the bricks from the floor of the firebox.
2)If using ashdrawer, discard cover plate.
3)Remove the ash dump cover plates (one inside the firebox and one on the underside of the firebox) by removing the two nuts and bolts holding the 2 plates together from inside the firebox.
4)Push the ash plug into the hole inside the firebox and replace all the bricks except for the brick over the ash plug. See the brick diagrams on page 17.
5)Place the ash drawer lid inside the pedes- tal, and the ash plug tool beside the lid, then slide the ash drawer inside so it sits on top of the lid.
See page 20 for Ash Drawer Operating in- structions.
Bottom Shield Ash Drawer Kit
(850-101 )
Freestanding - Medium
F2100 & S2100
OPTIONAL
ACCESSORIES
The pieces listed below can be purchased and installed during the initial installation or added on later.
1)Remove the bricks from the floor of the firebox.
2)Remove and discard the cover plate by removing the two screws on the front of the Bottom Shield.
3)Remove the ash dump cover plates (one inside the firebox and one on the underside of the firebox) by removing the two nuts and bolts holding the 2 plates together from inside the firebox.
4)Push the ash plug into the hole inside the firebox and replace all the bricks except for the brick over the ash plug. See the brick diagrams on page 16.
5)Place the ash plug tool beside the lid, then slide the ash drawer inside.
Freestanding - Large F3100
See page 20 for Ash Drawer Operating in- structions.
Regency Freestanding Woodstove | 17 |