Lopi Horizontal Or Vertical Vent Freestanding Stove Yankee Pellet Stove manual

Page 17

Installation (For Qualified Installers Only)

1 7

Installation Example: Zero-Clearance (Metal) Fireplace Hearth Stove

Vertical Cap

Cover Plate (non-combustible)

Storm Collar

Silicone

Seal the cover plate with silicone.

“L” Vent

.RTV °F 500Silicone

Seal each vent section (including adapters, elbows, etc...) by injecting a liberal amount of 500° F. RTV silicone into the gap between sections.

“L” Vent Flex

Section

Allow room for the hopper lid to open

53-3/8”

3”

6” Min.

NOTE: you will probably need a short horizontal section here to clear the lintel and allow the hopper lid to open.

Travis Industries

4050418

1 0 0 - 0 1 1 5 6

Image 17

Contents Yankee Introduction Important Information 2IntroductionTravis Industries 0 0 1 1 5Table of Contents 4Safety Precautions Mobile Home Specifications Planning The Installation Installation OptionsStove Placement Before You BeginClearances Corner Installation Clearances Straight InstallationMaximum Venting Distance Venting the Pellet StovePellet Vent Termination See the illustration below Installing the Pellet VentPellet Vent Type Outside Air used for combustion Mobile Home RequirementsBaffle Installation Alcove Installation RequirementsRestrictor Adjustment Door Seal VerificationInstallation Example Direct Through-the-wall Installation Installation Example Interior Vertical Installation Installation Example Class a Chimney Retrofit Vent Flex Section Installation Example Masonry Fireplace Hearth StoveVertical Cap Cover Plate non-combustible Storm Collar Storm Collar Installation Example Freestanding Masonry ChimneyOperation1 Safety NoticeLocation of Controls Starting the Heater for the First TimeTwo Modes of Operation 0Operatio nLoading Pellets To Adjust the Heat Manual ModeOperation2 To Start2Operation Auto ModeTo Adjust Room Temperature or Start the Stove Adjusting the Fan Speed 4Operation Daily Maintenance whenever using the stove Maintenance2Inspect the Burn Make Sure Pellets are Not Piling UpCheck Firepot for Clinkers 6MaintenanceCleaning the Firepot Door Frame Lock Nut Door OpeningBi-Weekly Maintenance or every 10 bags of pellets 8MaintenanceClean the Heat Exchange Tubes Cleaning the Optional Gold Surfaces Door and optional GrillCleaning the Baffles Clean the BafflesSweep Ash Into Ashpan 0MaintenanceCheck Ashpan, Dispose if necessary Maintenance3Clean the Glass Yearly Maintenance or every two tons 2MaintenanceClean the Exhaust Duct Clean the Convection BlowerClean the Vent make sure the stove and vent is cool Door Alignment 4MaintenanceDoor Seal Latch Adjustment Adjusting the Door Hinge and LatchCheck for Air Leaks Around the Door, Glass, and Ashpan Replacement PartsExhaust Blower Normal Operating SoundsSerial No Safety LabelYears 1 & 2 Coverage Parts & Labor Limited 7 Year WarrantyThermostat 0Optional EquipmentOptional Equipment Using the Remote ThermostatRemote Thermostat Pellet Log2Index