2 0Operatio n
Loading Pellets
Lift the hopper lid to its vertical position. Pour pellets into the hopper until full.
To Close the Hopper Lid:
To Open the Hopper Lid: | lift the lid, pull this bar forward, |
lift the hopper lid from this | then lower the lid down. |
| |
handle. |
|
e | lle |
P | |
| t |
| s |
Make sure pellets 
are not left on this
heat shield.
Warning:
The front edge of the hopper lid becomes very
hot, do not touch the area below the handle.
These notches allow
you to open the hopper 
lid to the level you wish.
The Two Modes of Operation:
Manual
Manual mode requires the user to turn the heater on and off manually.
Auto (requires a thermostat)
Auto mode allows you to use a thermostat to control room temperature. The stove automatically turns on when the temperature drops below the thermostat setting. Once the stove reaches operating temperature, the stove then runs at the heat output setting selected.
Switching Modes While in Operation
Whenever the stove is switched from one mode to another while in operation, the stove will enter the "start- up" sequence for a minimum of 20 minutes.
DISCONNECT POWER BEFORE SERVICE
H |
|
E | REMOTE |
A | HIGH |
T | AUTO |
| |
O | MANUAL |
MED | |
U |
|
TAUGER
P LOW
U |
| FAULT |
T |
|
|
|
| AUTO |
H | UP | OFF |
EMANUAL
A
T 
DOWN MANUAL
UP START
F
AMANUAL
N
DOWN
AUGER
TM
TRAVIS INDUSTRIES
HOUSE OF FIRE
NOTE: if using a modulating remote, this light will come on to indicate the remote is controlling the heater.
These indicator lights are used to determine which mode you are in.
Use the mode switch to determine the mode.
Travis Industries | 4050418 | 1 0 0 - 0 1 1 5 6 |