Optional Equipment | 4 1 |
Remote Thermostat
•Follow the instructions included with the remote thermostat for installation.
Using the Remote Thermostat
The remote thermostat has a 1 to 2 minute lag time between the time the thermostat is turned up and the heater turns on. Included with the remote thermostat is a set of instructions that details the operating characteristics of this optional component.
Pellet Log (part # 98900126)
1 Assemble the log shelf (with log shelf extender) following the directions below.
The log shelf assembly should
Left Log Shelf Leg
Right Log Shelf Leg
Nuts
Log Shelf Cross Brace
3/8" Nutdriver
Log Shelf
Extender
Slide the log shelf extender onto the log shelf assembly. Use a hammer to tap the extender fully into place.
like like this when done.
a
2Remove the firepot from the pellet stove. Center the log shelf assembly (with extender attached) over the burnpot holder. Replace the burnpot. Place the log on the log shelf extender. When in place the log should appear as shown in the picture below.
Remove the burnpot.
b
Center the log shelf over the burnpot holder. Slide it all the way back against the fireback.
d
Center the log on the log shelf extender and push it back so it rests against these two pins.
The log should look like this when installed.
cReplace the burnpot.
Travis Industries | 4050418 | 1 0 0 - 0 1 1 5 6 |