Lopi Horizontal Or Vertical Vent Freestanding Stove Yankee Pellet Stove Safety Label, Serial No

3 8 Safety Label

WARNING - DO NOT REMOVE OR COVER THIS LABEL

	Listed Pelletized
	Solid Fuel Burning Appliance	Serial No:
	Also for Use in Mobile Homes
Report No. 028-S-62-2	Model: Yankee PS

Tested to: ASTM E, 1509, and ULC-C1482-M1990 Room Heater Pellet Burning Type (UM) 84 HUD

Electrical Rating: 115V, 60Hz, 3 Amp; Start 3 Amps, Run 1.5 Amps

Maximum Input Rating: 5.5 lbs (2.5kg)/hr

This pellet fired appliance has been tested and listed for use in manufactured (mobile) homes in accordance with OAR 814-23-900 through 814-23-909.

WARNING - FOR MANUFACTURED HOMES: Do not install appliance in a sleeping room. Must utilize outside combustion air inlet (part #99200136) or equivalent. Structural integrity of the manufactured home floor, ceiling, and walls must be maintained.

Install only in accordance with the manufacturer’s installation and operating instructions. Contact local building or fire officials about restrictions and installation inspection in your area.

Use only listed 4 in./100 mm diameter listed type “L” or “PL” venting system. See manufacturer’s installation instructions and local codes for precautions required for passing chimney through a combustible wall or ceiling. Do not connect this appliance to a vent serving another appliance. Inspect and clean exhaust venting system frequently in accordance with manufacturer’s instructions.

May be installed in a sleeping room with use of outside combustion air inlet (Part #99200136) or equivalent.

Minimum Clearance to Combustible Materials (Measured to Stove Top)

		Interior Vertical	Horizontal Through
		Flue Installation	the Wall Installation
Left Sidewall	A	9”	9”
Right Sidewall	B	9”	9”
Backwall	C	**	3”
Corner	D	3”	3”
Flue Vent	E	3”	3”

BACKWALL

SIDEWALLLEFT		C	E	SIDEWALLRIGHT
	A		B
	H	G	H

FLOOR PROTECTOR

ADJACENT WALL

ADJACENT WALL

D

D

Maximum alcove depth 48 in/1220 mm, minimum ceiling height 60 in/1525 mm, minimum alcove width 44 in/1115 mm.

Combustible floor must be protected by a non-combustible material, extending to the front (G) 6 in/150 mm and to the sides (H) 0 in/0 mm.

EXCEPTIONS: Non-combustible floor protection must extend beneath a vent tee when installed. ** This dimension will vary depending on brand of listed type “L” vent. See manual for details.

For use with 1/4 in/6 mm to 5/16 in/7 mm diameter pelletized wood fuels only. Replace glass only with 5 mm ceramic glass available from your dealer.

DANGER: Risk of electrical shock. Disconnect power supply before servicing. Route power cord away from unit. Do not route power cord beneath heater.

Operate only with viewing door and ash removal tray tightly closed. Do not obstruct combustion air openings. The space beneath heater must not be obstructed. Keep all furnishings away from heater.

Mfg. by TRAVIS INDUSTRIES, INC.

10850 117th Pl N.E.

Kirkland, WA 98033

U.S. ENVIRONMENTAL PROTECTION AGENCY

This model is exempt from EPA certification under 40 CFR 60.531 by definition

[Wood Heater (A) “Air-to-fuel Ratio”].

Date of Manufacture
2001 2002 2003 Jan Feb Mar Apr May Jun Jul	Aug Sep Oct Nov	Dec
DO NOT REMOVE THIS LABEL	MADE IN U.S.A.	????

Travis Industries 4050418 1 0 0 - 0 1 1 5 6