Lopi Leyden Pellet Stove manual Maintenance3, Bi-Weekly Maintenance or every 10 bags of pellets

Page 31

Maintenance3 1

Bi-Weekly Maintenance (or every 10 bags of pellets) - continued

Clean the Baffles

WARNING: Make sure the heater has fully cooled (approximately 25 minutes) before conducting service.

HINT: The more often you clean out flyash, the more efficient your heater will burn.

The baffles are found along the top of the firebox. The front edge has a slot that slides into a hook on the top of the firebox. The back rests on the back refractory. To remove, slide them inwards, pull them forward, and tilt them back to allow the accumulated flyash fall off into the firebox. Replace after cleaning.

Push up on the front portion of the left baffle and slide it to the right. Note how the rear edge of the baffle rests on the rear refractory.

Move the baffle forward and tilt the back down. This allows any built-up flyash to fall off the top of the baffle.

The right side baffle is removed in the same fashion. Note how the right side baffle is larger than the left side baffle.

Travis Industries

4061016

1 0 0 - 0 1 1 8 4

Image 31
Contents Leyden Travis Industries 2IntroductionIntroduction Important InformationTable of Contents 4Safety Precautions Mobile Home Safety Precautions6Specifications Before You Begin Installation OptionsPlanning The Installation Stove PlacementInstallation Clearances Straight InstallationClearances Corner Maximum Venting Distance Venting the Pellet StovePellet Vent Type Installing the Pellet VentPellet Vent Termination Outside Air used for combustion Mobile Home RequirementsDoor Seal Verification Alcove Installation RequirementsBaffle Installation Restrictor AdjustmentThermostat Installation Installation Example Direct Through-the-wall Installation Min Ceiling Support / Fire Stop Spacer Vent Installation Example Interior Vertical InstallationInstallation Example Class a Chimney Retrofit Installation Example Masonry Fireplace Hearth Stove Vertical Cap Cover Plate non-combustible Storm Collar Vent Flex Section Installation Example Freestanding Masonry ChimneyStarting the Heater for the First Time Safety Notice0Operation Location of ControlsLoading Pellets Operation2Two Modes of Operation To Start Manual ModeTo Adjust the Heat 2OperationTo Adjust Room Temperature or Start the Stove Auto Mode4Operation Adjusting the Fan SpeedManual Auger Button Fault LightPower Outages Start-Up Sequence6Operation Using a Pellet/Corn Mix with This HeaterMake Sure Pellets are Not Piling Up Maintenance2Daily Maintenance whenever using the stove Inspect the BurnCleaning the Firepot 8MaintenanceCheck Firepot for Clinkers Door Opening Bi-Weekly Maintenance or every 10 bags of pellets 2MaintenanceBi-Weekly Maintenance or every 10 bags of pellets Maintenance3Clean the Baffles Sweep Ash Into Ashpan Check Ashpan, Dispose if necessary Clean the GlassYearly Maintenance or every two tons 4MaintenanceClean the Vertical Exhaust Duct Maintenance3 Clean the Exhaust Blower 6MaintenanceCheck for Air Leaks Around the Door, Glass, and Ashpan Clean the Convection BlowerClean the Vent Adjusting the Door Hinge and LatchDoor Replacement Replacement PartsReplacement Parts Convection Fan Normal Operating SoundsSafety Label Years 1 & 2 Coverage Parts & Labor Limited 7 Year Warranty2Index