Lopi Leyden Pellet Stove manual Check Ashpan, Dispose if necessary, Clean the Glass

Page 33

Maintenance3 3

Bi-Weekly Maintenance (or every 10 bags of pellets) - continued

Check Ashpan, Dispose if necessary

WARNING: Make sure the heater has fully cooled (approximately 25 minutes) before conducting service.

WARNING: The ashpan must be in place while the heater is in use.

Lift up on the ashlip and slide the ashpan forward.

Twist the ashpan handle clockwise.

A handle is provided on the ashpan to remove the ashes.

Disposal of Ashes – Ashes should be placed in a metal container with a tight fitting lid. The closed container of ashes should be placed on a noncombustible floor or on the ground, well away from all combustible materials, pending final disposal. If the ashes are disposed of by burial in soil or otherwise locally dispersed, they should be retained in the closed container until all cinders have been thoroughly cooled.

Clean the Glass

Open the doors and clean the glass with a non-abrasive glass cleaner and rag.

Travis Industries

4061016

1 0 0 - 0 1 1 8 4

Image 33
Contents Leyden Introduction 2IntroductionImportant Information Travis IndustriesTable of Contents 4Safety Precautions Mobile Home Safety Precautions6Specifications Planning The Installation Installation OptionsStove Placement Before You BeginClearances Straight Installation InstallationClearances Corner Maximum Venting Distance Venting the Pellet StoveInstalling the Pellet Vent Pellet Vent TypePellet Vent Termination Outside Air used for combustion Mobile Home RequirementsBaffle Installation Alcove Installation RequirementsRestrictor Adjustment Door Seal VerificationThermostat Installation Installation Example Direct Through-the-wall Installation Min Ceiling Support / Fire Stop Spacer Vent Installation Example Interior Vertical InstallationInstallation Example Class a Chimney Retrofit Installation Example Masonry Fireplace Hearth Stove Vertical Cap Cover Plate non-combustible Storm Collar Vent Flex Section Installation Example Freestanding Masonry Chimney0Operation Safety NoticeLocation of Controls Starting the Heater for the First TimeOperation2 Loading PelletsTwo Modes of Operation To Adjust the Heat Manual Mode2Operation To StartTo Adjust Room Temperature or Start the Stove Auto Mode4Operation Adjusting the Fan SpeedPower Outages Fault LightStart-Up Sequence Manual Auger Button6Operation Using a Pellet/Corn Mix with This HeaterDaily Maintenance whenever using the stove Maintenance2Inspect the Burn Make Sure Pellets are Not Piling Up8Maintenance Cleaning the FirepotCheck Firepot for Clinkers Door Opening Bi-Weekly Maintenance or every 10 bags of pellets 2MaintenanceMaintenance3 Bi-Weekly Maintenance or every 10 bags of pelletsClean the Baffles Sweep Ash Into Ashpan Check Ashpan, Dispose if necessary Clean the Glass4Maintenance Yearly Maintenance or every two tonsClean the Vertical Exhaust Duct Maintenance3 Clean the Exhaust Blower 6MaintenanceClean the Vent Clean the Convection BlowerAdjusting the Door Hinge and Latch Check for Air Leaks Around the Door, Glass, and AshpanReplacement Parts Door ReplacementReplacement Parts Convection Fan Normal Operating SoundsSafety Label Years 1 & 2 Coverage Parts & Labor Limited 7 Year Warranty2Index