Lopi Endeavor owner manual Mobile Home Requirements

Page 13

Stove Installation (for qualified installers only)

13

Mobile Home Requirements

Outside air must be installed - see "Outside Air Requirements" on page 11

Chimney connector and chimney must be one of the following types:

AMERI-TEC model DCC with model HS chimney

DURAVENT model DVL with DURATEC or DURA-PLUS chimney

GSW Super Chimney Twenty-One connected directly to appliance

I.C.C. Excel (2100-2 Can.) (103-HT USA) chimney with HP connector

METALFAB model DW connector with TG chimney

OLIVER MACLEOD PROVENT model PV connector with model 3103 chimney

SECURITY model DP connector with SECURITY model ASHT or S2100 chimney

SELKIRK METALBESTOS model DS connector with model SSII chimney

Standard Masonry Chimney with any one of the above listed connectors

NOTE: Reduced clearance connectors may not connect to the flue collar – an appliance adapter may be required.

Stove placement must maintain the following clearances to combustibles (drywall, furniture, etc.)

 

 

Rear heat

 

b

e

shield

c

a

 

 

 

d

f

c

Measure all clearances from the nearest edge of the stove top.

Minimum Clearance

Reduced Clearance

(See the illustration above)

Connector

 

 

 

A

Sidewall to stove

15"

B

Backwall to stove

6"

C

Cornerwall to stove

6-1/2"

D

Connector to sidewall

23-1/2"

E

Connector to backwall

8-1/4"

F

Connector to cornerwall

15"

If using offsets, use the connector clearance listed in Figure 9, not the connector manufacturer's clearance.

The appliance must be secured to the floor (consult your building official). Secure the outside air boot to the floor and stove to insure the stove does not dislocate.

Mobile home installations require a spark arrester at the

chimney termination.

The appliance must be grounded to the chassis of the mobile home (consult your building official).

WARNING:DO NOT INSTALL IN SLEEPING ROOM.

CAUTION:THE STRUCTURAL INTEGRITY OF THE MOBILE HOME FLOOR, WALL, AND CEILING/ROOF MUST BE MAINTAINED.

Figure 8

12” Min.

Minimum Connector Clearance

(as outlined above)

Minimum Stove Clearance

(as outlined above)

Figure 9

© Travis Industries

100-01161

4040608

Image 13
Contents Endeavor Wood Stove 2Introduction Mail your Warranty Card Today, and Save Your Bill of SaleIntroduction Important Information Table of Contents Ashes Safety PrecautionsMobile Travis Industries, Inc. grants no warranty, implied orFeatures & Specifications Preparation for Installation Planning The InstallationAdditional Accessories Needed for Installation Stove Installation ConsiderationsMinimum Clearance Singlewall Reduced Connector Stove Placement RequirementsFloor Protection Requirements ClearancesTop View Corner Installation Top View Straight InstallationDrafting Chimney RequirementsPerformance Outside Air Requirements Chimney Termination RequirementsAlcove Installation Requirements Mobile Home Requirements Cathedral Ceiling with a Factory Built Chimney Standard Ceiling with a Factory BuiltHearth Stove Positive Connection Exterior Factory Built ChimneyInterior or Exterior Masonry Chimney Hearth Stove Direct ConnectionOperating Your Appliance Safety NoticeBefore Your First Fire Opening the DoorBypass Operation Starting a Fire Approximate Air Control Settings Adjusting the Burn RateAsh Removal Re-Loading the Stove Optional Blower OperationOvernight Burn Normal Operating SoundsHints for Burning Why Dry Wood is KeySelecting Wood Wood Cutting and StorageTroubleshooting Clean the Glass if necessary Daily Maintenance while stove is in useMaintaining Your Appliance Remove Ash if necessaryDoor and Glass Inspection Monthly Maintenance while appliance is in useCreosote Formation and Need for Removal Cleaning the Air Duct and Blower if applicable Yearly MaintenanceTouch Up Paint Firebrick and Baffle InspectionReplacing the Glass Door PartsReplacing the Door Gasket Replacing the Door HandleFirebox Parts Floor and Side Firebrick Removal & ReplacementAir Tube Removal & Replacement Baffle Removal & ReplacementYears 1 & 2 Coverage Parts & Labor Limited 7 Year WarrantyYears 3 Through 5 Coverage Parts & Labor Years 6 & 7 Coverage Parts onlyListing Label Listing InformationOptional Equipment Door Shell InstallationHex Wrench Stove Leg Installation Pedestal Using Outside Air with the PedestalInstall the wire clip following the directions below Rear Blower InstallationOutside Air Boot Installation Part number Index