Lopi Endeavor owner manual Baffle Removal & Replacement, Air Tube Removal & Replacement

Page 29

Maintaining Your Appliance

29

Baffle Removal & Replacement

1Push the front firebricks up and feed them forward, guiding them out the door. Repeat for the rear firebricks.

Bypass Rod (& Yoke)

Front Baffle Support

Baffle Firebrick

 

 

Bypass Damper

Front Air Tube

Bypass Support

 

 

Bypass Gasket

Support Tabs

Center Baffle Support

2The baffle supports rest on support tabs.

3The bypass support and damper are difficult to remove and should only be removed if necessary. Remove the rear secondary air tube (see the following section for instructions). Slide the bypass support forward until the bypass rod can be disconnected from the bypass damper. Slide the damper forward and remove. The bypass support is removed by sliding it forward and rotating it downwards (the bypass holder fits very snug inside the firebox and is very heavy, making it difficult to remove). The bypass gasket rests on the side and rear air channels. Try not to damage it when removing the bypass holder.

Air Tube Removal & Replacement

Air Tube Collar

 

Air Tube

Remove the left pin on the air tube collar

a

Roll Pin

b Slide the air tube to the left, swing it down and remove from the firebox.

© Travis Industries

100-01161

4040608

Image 29
Contents Endeavor Wood Stove Introduction Important Information Mail your Warranty Card Today, and Save Your Bill of Sale2Introduction Table of Contents Ashes Safety PrecautionsMobile Travis Industries, Inc. grants no warranty, implied orFeatures & Specifications Preparation for Installation Planning The InstallationAdditional Accessories Needed for Installation Stove Installation ConsiderationsMinimum Clearance Singlewall Reduced Connector Stove Placement RequirementsFloor Protection Requirements ClearancesTop View Corner Installation Top View Straight InstallationPerformance Chimney RequirementsDrafting Outside Air Requirements Chimney Termination RequirementsAlcove Installation Requirements Mobile Home Requirements Cathedral Ceiling with a Factory Built Chimney Standard Ceiling with a Factory BuiltHearth Stove Positive Connection Exterior Factory Built ChimneyInterior or Exterior Masonry Chimney Hearth Stove Direct ConnectionOperating Your Appliance Safety NoticeBefore Your First Fire Opening the DoorBypass Operation Starting a Fire Ash Removal Adjusting the Burn RateApproximate Air Control Settings Re-Loading the Stove Optional Blower OperationOvernight Burn Normal Operating SoundsHints for Burning Why Dry Wood is KeySelecting Wood Wood Cutting and StorageTroubleshooting Clean the Glass if necessary Daily Maintenance while stove is in useMaintaining Your Appliance Remove Ash if necessaryCreosote Formation and Need for Removal Monthly Maintenance while appliance is in useDoor and Glass Inspection Cleaning the Air Duct and Blower if applicable Yearly MaintenanceTouch Up Paint Firebrick and Baffle InspectionReplacing the Glass Door PartsReplacing the Door Gasket Replacing the Door HandleFirebox Parts Floor and Side Firebrick Removal & ReplacementAir Tube Removal & Replacement Baffle Removal & ReplacementYears 1 & 2 Coverage Parts & Labor Limited 7 Year WarrantyYears 3 Through 5 Coverage Parts & Labor Years 6 & 7 Coverage Parts onlyListing Label Listing InformationOptional Equipment Door Shell InstallationHex Wrench Stove Leg Installation Pedestal Using Outside Air with the PedestalInstall the wire clip following the directions below Rear Blower InstallationOutside Air Boot Installation Part number Index