Lopi Endeavor owner manual Adjusting the Burn Rate, Ash Removal, Approximate Air Control Settings

Page 20

20

Operating Your Appliance

Adjusting the Burn Rate

Use the air control slider to control the burn rate of the stove. See the illustration below for details.

Use the air control to change the burn rate.

Low Burn

High Burn

(air control closed)

(air control open)

Approximate Air Control Settings

Overnight Burn

Fully in to 1/8" open

Medium Burn

1/8" to 5/8" open

Medium High Burn

5/8" to fully open

High Burn

Fully open (pulled out)

The air control becomes hot during operation - use gloves or a tool to prevent burns.

The air control may take several minutes to influence the burn rate. When making adjustments, you may wish to let the stove burn for 10 minutes to gauge performance.

Ash Removal

Ashes should be placed in a metal container with a tight fitting lid. The closed container of ashes should be placed on a noncombustible floor or on the ground, away from all combustible

ASHES materials, pending final disposal. If the ashes are disposed of by burial in soil or otherwise locally dispersed, they should be retained in the closed container until all cinders have thoroughly cooled.

© Travis Industries

100-01161

4040608

Image 20
Contents Endeavor Wood Stove Introduction Important Information Mail your Warranty Card Today, and Save Your Bill of Sale2Introduction Table of Contents Safety Precautions AshesTravis Industries, Inc. grants no warranty, implied or MobileFeatures & Specifications Planning The Installation Preparation for InstallationAdditional Accessories Needed for Installation Stove Installation ConsiderationsStove Placement Requirements Minimum Clearance Singlewall Reduced ConnectorFloor Protection Requirements ClearancesTop View Straight Installation Top View Corner InstallationPerformance Chimney RequirementsDrafting Chimney Termination Requirements Outside Air RequirementsAlcove Installation Requirements Mobile Home Requirements Standard Ceiling with a Factory Built Cathedral Ceiling with a Factory Built ChimneyExterior Factory Built Chimney Hearth Stove Positive ConnectionHearth Stove Direct Connection Interior or Exterior Masonry ChimneySafety Notice Operating Your ApplianceBefore Your First Fire Opening the DoorBypass Operation Starting a Fire Ash Removal Adjusting the Burn RateApproximate Air Control Settings Optional Blower Operation Re-Loading the StoveOvernight Burn Normal Operating SoundsWhy Dry Wood is Key Hints for BurningSelecting Wood Wood Cutting and StorageTroubleshooting Daily Maintenance while stove is in use Clean the Glass if necessaryMaintaining Your Appliance Remove Ash if necessaryCreosote Formation and Need for Removal Monthly Maintenance while appliance is in useDoor and Glass Inspection Yearly Maintenance Cleaning the Air Duct and Blower if applicableTouch Up Paint Firebrick and Baffle InspectionDoor Parts Replacing the GlassReplacing the Door Gasket Replacing the Door HandleFloor and Side Firebrick Removal & Replacement Firebox PartsBaffle Removal & Replacement Air Tube Removal & ReplacementLimited 7 Year Warranty Years 1 & 2 Coverage Parts & LaborYears 3 Through 5 Coverage Parts & Labor Years 6 & 7 Coverage Parts onlyListing Information Listing LabelDoor Shell Installation Optional EquipmentHex Wrench Stove Leg Installation Using Outside Air with the Pedestal PedestalRear Blower Installation Install the wire clip following the directions belowOutside Air Boot Installation Part number Index