Lopi Endeavor owner manual Chimney Termination Requirements, Outside Air Requirements

Page 11

Stove Installation (for qualified installers only)

11

Chimney Termination Requirements

Must have an approved cap (to prevent water from entering)

Must not be located where it will become plugged by snow or other material

Must terminate at least 3' above the roof and at least 2' above any portion of the roof within 10' (see Figure 5)

Slanted Roofs

Chimney must extend 3' above the roof

Flat

Chimney must extend 3' above the roof

Chimney must extend 2' above any portion of the roof within 10' of the chimney

Chimney must extend 2' above any portion of the roof within 10' of the chimney

Figure 5

Outside Air Requirements

Required for mobile homes & in certain localities (check with building officials)

Must not be drawn from an enclosed space (garage, unventilated crawl space)

Requires the optional outside air boot (for legs) or pedestal

When using outside air, find a location where the chimney and outside air hole do not interfere with structural members of the home

Pedestal (with insulation) directs air to the stove

Air may be drawn from a ventilated crawl space or use an air duct.

A hole must be cut

 

 

through the floor

Outside

protection and floor

Air Boot

and the rodent

 

 

screen nailed in

 

 

place here (see the

 

 

 

 

optional equipment

 

 

instructions for

 

 

 

 

exact sizes)

 

 

Optional Air Duct (must not be longer than 15' and at least 16 square inches in cross section)

Outside air entrance must be placed so it does not become blocked by snow.

Figure 6

© Travis Industries

100-01161

4040608

Image 11
Contents Endeavor Wood Stove Introduction Important Information Mail your Warranty Card Today, and Save Your Bill of Sale2Introduction Table of Contents Ashes Safety PrecautionsMobile Travis Industries, Inc. grants no warranty, implied orFeatures & Specifications Stove Installation Considerations Planning The InstallationPreparation for Installation Additional Accessories Needed for InstallationClearances Stove Placement RequirementsMinimum Clearance Singlewall Reduced Connector Floor Protection RequirementsTop View Corner Installation Top View Straight InstallationPerformance Chimney RequirementsDrafting Outside Air Requirements Chimney Termination RequirementsAlcove Installation Requirements Mobile Home Requirements Cathedral Ceiling with a Factory Built Chimney Standard Ceiling with a Factory BuiltHearth Stove Positive Connection Exterior Factory Built ChimneyInterior or Exterior Masonry Chimney Hearth Stove Direct ConnectionOpening the Door Safety NoticeOperating Your Appliance Before Your First FireBypass Operation Starting a Fire Ash Removal Adjusting the Burn RateApproximate Air Control Settings Normal Operating Sounds Optional Blower OperationRe-Loading the Stove Overnight BurnWood Cutting and Storage Why Dry Wood is KeyHints for Burning Selecting WoodTroubleshooting Remove Ash if necessary Daily Maintenance while stove is in useClean the Glass if necessary Maintaining Your ApplianceCreosote Formation and Need for Removal Monthly Maintenance while appliance is in useDoor and Glass Inspection Firebrick and Baffle Inspection Yearly MaintenanceCleaning the Air Duct and Blower if applicable Touch Up PaintReplacing the Door Handle Door PartsReplacing the Glass Replacing the Door GasketFirebox Parts Floor and Side Firebrick Removal & ReplacementAir Tube Removal & Replacement Baffle Removal & ReplacementYears 6 & 7 Coverage Parts only Limited 7 Year WarrantyYears 1 & 2 Coverage Parts & Labor Years 3 Through 5 Coverage Parts & LaborListing Label Listing InformationOptional Equipment Door Shell InstallationHex Wrench Stove Leg Installation Pedestal Using Outside Air with the PedestalInstall the wire clip following the directions below Rear Blower InstallationOutside Air Boot Installation Part number Index