Step-by-step instructions
!In addition to the guide below it is essential that the written instructions overleaf are read and understood and that you have all the necessary
components (shown overleaf) before commencing installation. Failure to install the product in accordance with these instructions may adversely affect the warranty terms and conditions. Do not undertake any part of this installation unless you are competent to do so. Prior to starting ensure that you are familiar with the necessary plumbing regulations required to install the product correctly and safely.
!Quartz Thermo is supplied with universal fixings.
1If installing the product built in to a solid wall, chase out a suitable recess in the wall to receive the valve and pipe work. If installing the valve in a
concealed panel mounted situation, in most cases it will be necessary to first install a suitable sound fixing in the cavity area before fixing the valve.
A hole of ø130mm is required to install the valve and gain access to inlet and outlet connectors.
The valve needs to be mounted to the depth shown at the following centres. The distance between the 15mm inlet centre pipe centres is 150mm as shown.
| 150mm |
65mm | Supply pipes hot on |
| left, cold on right |
| 65mm |
100mm max. |
|
to finished/ |
|
tiled wall | 60mm |
surface | min. from |
| back face |
| of valve to |
| finished/ |
| tiled wall |
| surface |
| (10mm |
| allowance |
| for tiles) |
2
3
Mark the position for the four fixing points as outlined above.
Carefully remove the valve from its packaging and retain the mortar guard for later use.
4Remove the on/off lever assembly, if fitted, from the valve by carefully pulling the
assembly away from the valve (a screw is provided in the screwpack to secure the on/off lever assembly to the valve towards the end of installation).
Quartz Thermo installation guide |
| page 5 |
|
|
|