Nilfisk-Advance America SW 700S P manuel dutilisation Machine Operation, Stopping the machine

Page 53

USER MANUAL

ENGLISH

WARNING!

The engine cannot be started with the handle (28) when the hood (7) is open. A safety system prevents the engine from starting.

NOTE

When the engine is running, the main broom turns, while the side broom does not move, if lifted.

7.5 seconds after the engine has been running, disengage the engine choke lever (A, Fig. 3) by introducing the hand into the compartment (29), without opening the hood (7).

8.Release the pedal brake (26) (optional).

9.Lower the side broom (10), then disengage the fastener (2) and lower the knob (12) (without turning it).

NOTE

The side broom (10) can be lifted and lowered even if it is turned on.

10.Pull the drive lever (4) with care until the machine starts to move. The speed is proportional to the pressure applied to the drive lever (4).

Stopping the machine

1.To stop the machine, release the drive lever (4) completely.

2.To turn off the side broom (10) lift the knob (12) (without turning it), and then engage the fastener (2).

3.To turn off the main broom (11) and the vacuum fan (64), turn the ignition key (71) to “0”.

4.Then close the fuel tap (48) in the compartment (29).

MACHINE OPERATION

1.Avoid stopping for a long time with the machine in the same position and the brooms turning: this could create unwanted marks on the floor.

2.For machine proper operation, the dust filter must be as clean as possible. To clean the filter while sweeping, turn on the filter shaker according to the following procedure:

•Pull the handle (20) outward to the end of stroke, then suddenly release it; the inner return spring thus strikes the dust filter frame and shakes it. Repeat this procedure several times.

NOTE

Repeat the filter shaking procedure at least every 10 minutes. This interval can change depending on the dustiness of the area to be cleaned.

NOTE

When the dust filter is clogged and/or the debris container is full, the machine cannot collect dust and debris anymore.

CAUTION!

Do not work on wet floors to prevent the dust filter from being damaged.

3.The debris container (17) should be emptied after each working cycle and whenever it is full.

CAUTION!

The engine is equipped with a warning system to prevent damages to the engine itself in case the oil quantity in the carter is insufficient. Before the oil level goes below the safety limit, the warning system automatically stops the engine.

SW 700S P

146 0676 000(5)2007-06 A

11

Page 52 Page 54
Image 53
Page 52 Page 54
Contents 146 0676 00052007-06 a Sweeper SW 700S PSW 700S P SweeperEinleitung InhaltsverzeichnisEinleitung Sicherheit AUSPACKEN/AUSLIEFERUNGAllgemeine Hinweise Betriebsanleitung Deutsch Maschinenaufbau MaschinenbeschreibungMaschinenaufbau fortgesetzt ZUBEHÖRE/OPTIONEN SchalttafelFarbencodes Technische DatenSchaltplan VOR DEM Anlassen BetriebMaschinenanlassen UND -ABSTELLEN MaschinenanlassenMaschinenabstellen Maschine in BetriebWartung Stunden Übersichtstabelle DER Planmässigen WartungBei Einlaufzeit Alle Vorgang Prüfung UND Einstellung DER Hauptkehrwalzenhöhe Ersetzen DER Hauptkehrwalze Ersetzen DES Seitenbesens Prüfung UND Einstellung DER SeitenbesenhöheReinigung UND Vollständigkeitsprüfung DES Staubfilters Prüfung der Seitenflaps Prüfung UND Einstellung DER FlapshöhePrüfung der Vorder- und Hinterflaps Flap linksFlap rechts Fehler Mögliche Ursache Lösung FehlersucheVerschrottung Introduction Table DES MatieresIntroduction Securite Deballage / LivraisonInstructions Generales Manuel Dutilisation Français Structure DE LA Machine Description DE LA MachineStructure DE LA Machine suite Tableau DE Bord Accessoires / OptionsLégende Codes des couleurs Schema ElectriqueCaracteristiques Techniques Avant LA Mise EN Marche UtilisationMise EN Marche ET Arret DE LA Machine Mise en marche de la machineArrêt de la machine Machine AU TravailEntretien Toutes Procédure Plan Dentretien ProgrammeLes HeuresControle ET Reglage DE LA Hauteur DU Balai Central Remplacement DU Balai Central Controle ET Reglage DE LA Hauteur DU Balai Lateral Remplacement DU Balai LateralNettoyage ET Controle DE Lintegrite DU Filtre a Poussiere Contrôle des volets latéraux Controle ET Reglage DE LA Hauteur DES VoletsContrôle des volets avant et arrière Volet gaucheVolet droit Problème Cause probable Remède Depistage DES PannesMise EN Decharge Table of Contents HOW to Keep this Manual Declaration of Conformity Manual Purpose and ContentsTarget Identification DataUNPACKING/DELIVERY SafetyGeneral Instructions English Machine Structure Machine DescriptionMachine Structure Continues Control Panel ACCESSORIES/OPTIONSKey Colour code Technical DataWiring Diagram Before Starting the Machine USEStarting and Stopping the Machine Starting the machineStopping the machine Machine OperationMaintenance Upon deli Running-in Every Procedure 100 Scheduled Maintenance Table300 HoursMain Broom Height Check and Adjustment Main Broom Replacement Side Broom Replacement Side Broom Height Check AdjustmentDust Filter Cleaning and Integrity Check Side skirt check Skirt Height Check and AdjustmentLeft skirt Hood Safety Switch Operation CheckRight skirt Front and rear skirt checkTrouble Possible cause Remedy TroubleshootingScrapping Inleiding InhoudsopgaveInleiding Veiligheid Verpakking VERWIJDEREN/AFLEVERINGAlgemene Instructies Gebruiksaanwijzing Nederlands Bouw VAN DE Machine Beschrijving VAN DE MachineOpbouw VAN DE Machine vervolg Bedieningspaneel Accessoires / OptiesKleurcodering Elektrisch SchemaTechnische Eigenschappen Voor HET Starten GebruikDE Machine Starten EN Stoppen Starten van de machineDe machine stoppen Machine in BedrijfOnderhoud Inloopperi Elke OnderhoudsschemaDE Hoogte VAN DE Hoofdborstel Controleren EN Afstellen DE Hoofdborstelvervangen DE Zijborstel Vervangen DE Hoogte VAN DE Zijborstel Controleren EN AfstellenReiniging EN Contole OP Integriteit VAN HET Stoffilter Controle van de zijflaps DE Hoogte VAN DE Flaps Controleren EN AfstellenControle van de voor- en achterflap LinkerflapRechterflap Probleem Waarschijnlijke oorzaak Oplossing Storingen LokaliserenVerwijdering

SW 700S P specifications

The Nilfisk-Advance America SW 700S P is an innovative and efficient machine that stands out in the realm of commercial cleaning equipment. Designed for optimal performance and user convenience, the SW 700S P combines state-of-the-art technology with robust features aimed at streamlining the cleaning process in a variety of industrial and commercial settings.

One of the standout features of the SW 700S P is its compact design, which allows for excellent maneuverability in tight spaces. This is particularly beneficial in environments such as retail stores, schools, and warehouses where space can often be limited. The machine’s low profile ensures that it can easily navigate around obstacles, providing thorough cleaning without disrupting daily operations.

Equipped with a powerful yet efficient motor, the SW 700S P delivers impressive cleaning capabilities. It utilizes a dual-suction system that maximizes dirt and debris pickup, ensuring a consistently clean surface. This technology not only enhances cleaning efficiency but also minimizes the need for frequent emptying of the waste container, allowing operators to focus on their tasks without interruption.

The machine incorporates user-friendly controls, making it accessible for operators of all experience levels. The ergonomic design features an adjustable handle that ensures comfort during prolonged use. Additionally, operators can easily switch between cleaning modes, optimizing the machine for various floor types and levels of dirt accumulation.

Another noteworthy technology is the integrated battery system that provides a sustainable power source, reducing the environmental footprint of the cleaning process. The SW 700S P features rapid charging capabilities, ensuring that it can be fully recharged and ready for use in minimal time, thus maximizing productivity throughout the day.

Maintenance is simplified with the SW 700S P, as daily upkeep can be performed quickly and efficiently. The machine features easily accessible components, allowing users to conduct routine inspections and cleaning with minimal effort. This not only extends the life of the equipment but also ensures consistent performance.

In summary, the Nilfisk-Advance America SW 700S P is a pioneering cleaning solution that combines versatility, efficiency, and ease of use. Its advanced features and technologies make it an invaluable asset for businesses looking to maintain cleanliness and hygiene standards while promoting operational efficiency.
Top Page Image Contents