Nilfisk-Advance America SW 700S P manuel dutilisation Dust Filter Cleaning and Integrity Check

Page 59

USER MANUAL

ENGLISH

DUST FILTER CLEANING AND INTEGRITY CHECK

NOTE

Besides the standard paper filter, polyester filters are also available. The following procedure is applicable to each type of filter.

1.Drive the machine on a level ground. Make sure that the machine cannot move independently; if equipped, press the pedal brake (26).

2.Turn the ignition key (71) to "0".

3.Disengage the debris container hook (18).

4.Remove the debris container (17) with the handle (19).

5.Turn the handle (A, Fig. 13) upwards (90° approximately) and let the filter frame (B) turn outward.

6.Remove the dust filter (C, Fig. 13).

7.In an outdoor area, clean the dust filter by shaking it on a level and clean surface, tapping the side (A, Fig. 14) opposite to the wire gauze (B).

8.Complete the cleaning procedure by using compressed air (C, Fig. 14) at maximum 6 Bar, blowing only from the side protected by the wire gauze (B).

Moreover, according to the filter type, observe the following cautions:

•Paper filter (standard): Do not use water or detergents to clean it, otherwise it can be damaged.

•Polyester filter (optional): For a better cleaning, it is allowed to wash the filter with water and non-lathering detergents. This provides better quality cleaning but reduces the life of the filter, which will have to be replaced more frequently. The use of inadequate detergents can damage the filter.

9.Check the filter body for tears.

10.If necessary, clean the filter compartment rubber gasket (D, Fig. 13) along its perimeter and check it for integrity. If necessary, replace it.

11.Assemble the components in the reverse order of disassembly, and note the following:

•Install the filter (C, Fig. 13) with the wire gauze (B, Fig.

14)turned towards the machine front side.

S311466

Figure 13

S311467

Figure 14

SW 700S P

146 0676 000(5)2007-06 A

17

Page 58 Page 60
Image 59
Page 58 Page 60
Contents 146 0676 00052007-06 a Sweeper SW 700S PSW 700S P SweeperEinleitung InhaltsverzeichnisEinleitung Sicherheit AUSPACKEN/AUSLIEFERUNGAllgemeine Hinweise Betriebsanleitung Deutsch Maschinenaufbau MaschinenbeschreibungMaschinenaufbau fortgesetzt ZUBEHÖRE/OPTIONEN SchalttafelFarbencodes Technische DatenSchaltplan Maschinenanlassen BetriebVOR DEM Anlassen Maschinenanlassen UND -ABSTELLENMaschinenabstellen Maschine in BetriebWartung Stunden Übersichtstabelle DER Planmässigen WartungBei Einlaufzeit Alle Vorgang Prüfung UND Einstellung DER Hauptkehrwalzenhöhe Ersetzen DER Hauptkehrwalze Ersetzen DES Seitenbesens Prüfung UND Einstellung DER SeitenbesenhöheReinigung UND Vollständigkeitsprüfung DES Staubfilters Prüfung der Seitenflaps Prüfung UND Einstellung DER FlapshöhePrüfung der Vorder- und Hinterflaps Flap linksFlap rechts Fehler Mögliche Ursache Lösung FehlersucheVerschrottung Introduction Table DES MatieresIntroduction Securite Deballage / LivraisonInstructions Generales Manuel Dutilisation Français Structure DE LA Machine Description DE LA MachineStructure DE LA Machine suite Tableau DE Bord Accessoires / OptionsLégende Codes des couleurs Schema ElectriqueCaracteristiques Techniques Mise en marche de la machine UtilisationAvant LA Mise EN Marche Mise EN Marche ET Arret DE LA MachineArrêt de la machine Machine AU TravailEntretien Heures Plan Dentretien ProgrammeToutes Procédure LesControle ET Reglage DE LA Hauteur DU Balai Central Remplacement DU Balai Central Controle ET Reglage DE LA Hauteur DU Balai Lateral Remplacement DU Balai LateralNettoyage ET Controle DE Lintegrite DU Filtre a Poussiere Contrôle des volets latéraux Controle ET Reglage DE LA Hauteur DES VoletsContrôle des volets avant et arrière Volet gaucheVolet droit Problème Cause probable Remède Depistage DES PannesMise EN Decharge Table of Contents Identification Data Manual Purpose and ContentsHOW to Keep this Manual Declaration of Conformity TargetUNPACKING/DELIVERY SafetyGeneral Instructions English Machine Structure Machine DescriptionMachine Structure Continues Control Panel ACCESSORIES/OPTIONSKey Colour code Technical DataWiring Diagram Starting the machine USEBefore Starting the Machine Starting and Stopping the MachineStopping the machine Machine OperationMaintenance Hours Scheduled Maintenance TableUpon deli Running-in Every Procedure 100 300Main Broom Height Check and Adjustment Main Broom Replacement Side Broom Replacement Side Broom Height Check AdjustmentDust Filter Cleaning and Integrity Check Side skirt check Skirt Height Check and AdjustmentFront and rear skirt check Hood Safety Switch Operation CheckLeft skirt Right skirtTrouble Possible cause Remedy TroubleshootingScrapping Inleiding InhoudsopgaveInleiding Veiligheid Verpakking VERWIJDEREN/AFLEVERINGAlgemene Instructies Gebruiksaanwijzing Nederlands Bouw VAN DE Machine Beschrijving VAN DE MachineOpbouw VAN DE Machine vervolg Bedieningspaneel Accessoires / OptiesKleurcodering Elektrisch SchemaTechnische Eigenschappen Starten van de machine GebruikVoor HET Starten DE Machine Starten EN StoppenDe machine stoppen Machine in BedrijfOnderhoud Inloopperi Elke OnderhoudsschemaDE Hoogte VAN DE Hoofdborstel Controleren EN Afstellen DE Hoofdborstelvervangen DE Zijborstel Vervangen DE Hoogte VAN DE Zijborstel Controleren EN AfstellenReiniging EN Contole OP Integriteit VAN HET Stoffilter Controle van de zijflaps DE Hoogte VAN DE Flaps Controleren EN AfstellenControle van de voor- en achterflap LinkerflapRechterflap Probleem Waarschijnlijke oorzaak Oplossing Storingen LokaliserenVerwijdering

SW 700S P specifications

The Nilfisk-Advance America SW 700S P is an innovative and efficient machine that stands out in the realm of commercial cleaning equipment. Designed for optimal performance and user convenience, the SW 700S P combines state-of-the-art technology with robust features aimed at streamlining the cleaning process in a variety of industrial and commercial settings.

One of the standout features of the SW 700S P is its compact design, which allows for excellent maneuverability in tight spaces. This is particularly beneficial in environments such as retail stores, schools, and warehouses where space can often be limited. The machine’s low profile ensures that it can easily navigate around obstacles, providing thorough cleaning without disrupting daily operations.

Equipped with a powerful yet efficient motor, the SW 700S P delivers impressive cleaning capabilities. It utilizes a dual-suction system that maximizes dirt and debris pickup, ensuring a consistently clean surface. This technology not only enhances cleaning efficiency but also minimizes the need for frequent emptying of the waste container, allowing operators to focus on their tasks without interruption.

The machine incorporates user-friendly controls, making it accessible for operators of all experience levels. The ergonomic design features an adjustable handle that ensures comfort during prolonged use. Additionally, operators can easily switch between cleaning modes, optimizing the machine for various floor types and levels of dirt accumulation.

Another noteworthy technology is the integrated battery system that provides a sustainable power source, reducing the environmental footprint of the cleaning process. The SW 700S P features rapid charging capabilities, ensuring that it can be fully recharged and ready for use in minimal time, thus maximizing productivity throughout the day.

Maintenance is simplified with the SW 700S P, as daily upkeep can be performed quickly and efficiently. The machine features easily accessible components, allowing users to conduct routine inspections and cleaning with minimal effort. This not only extends the life of the equipment but also ensures consistent performance.

In summary, the Nilfisk-Advance America SW 700S P is a pioneering cleaning solution that combines versatility, efficiency, and ease of use. Its advanced features and technologies make it an invaluable asset for businesses looking to maintain cleanliness and hygiene standards while promoting operational efficiency.
Top Page Image Contents