To reset engine-tank configuration | Lowrance electronic EP-80R TH

5.After all tanks on your vessel have been set up, press EXIT repeatedly to return to the main display.

Boat Setup Reset

If you want to access the Setup screen (Boat Setup) after an engine- tank configuration has been chosen you will have to reset the configu- ration to default settings.

To reset engine-tank configuration:

1.Press MENU, highlight SYSTEM SETUP and press ENTER.

2.Choose ENG/TANK CFG and press ENTER twice. The following message will appear: Press ENTER to reset Eng/Tnk Cfg.

3.Press MENU. The Setup Menu will appear with Boat Setup high- lighted.

EP-80R TH Configuration

The EP-80R TH Temperature sensor has three configuration options: Inside, Outisde and Water. An unconfigured temperature sensor will appear on the bus devices list as UnCfg Temp.

To configure a temp sensor:

1.Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and press ENTER.

2.Highlight BUS DEVICES and press ENTER. The Bus Devices list will ap- pear.

3.Select an unconfigured temp sensor (UNCFG TEMP) and press ENTER. The following message will appear: Press Enter to Configure Temp Sen- sor.

4.Press ENTER, which will open the Select Temp menu with three op- tions: Water Temp, Outside Temp and Inside Temp.

5.Highlight the desired option and press ENTER. The temp is now con- figured. You will be directed to the Bus Devices list. Press EXIT repeat- edly to get back to the main display.

NOTE:

If your temp sensor is not updated on the Bus Devices list, refresh the list by closing it and then access it again.

To unconfigure a temp sensor:

1.Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and press ENTER.

2.Highlight BUS DEVICES and press ENTER. The Bus Devices list will ap- pear, showing all devices detected on the network.