4.Press ENTER. Use the arrow keys to input the desired name for the temp sensor and press ENTER. Press EXIT repeatedly to return to the main display.
To reset device name to default setting:
1.Press MENU twice, select NMEA 2000 or NETWORKING and press ENTER. A menu will appear with five options: Bus Setup, Fuel Management, NMEA 2000 Alarms, Waypoint Sharing and Backlight Synchroniza- tion.
2.Highlight BUS SETUP and press ENTER, to open the Bus Configuration menu. A list of network devices will be at the top of the page.
3.Select the desired temp sensor and press ENTER. The Device Con- figuration menu will appear with the Device Name dialog box high- lighted.
4.Press ENTER. Depress the left arrow key until the device name dis- appears. Press ENTER, then press EXIT to return to the NMEA 2000 menu.
5.Highlight the device and press ENTER. The Device Configuration menu will open. The device name will be reset to its default setting. Press EXIT repeatedly to return to the main display.
To select Temp Type:
1.Press MENU twice, select NMEA 2000 or NETWORKING and press ENTER. A menu will appear with five options: Bus Setup, Fuel Management, NMEA 2000 Alarms, Waypoint Sharing and Backlight Synchroniza- tion.
2.Highlight BUS SETUP and press ENTER, which will open the Bus Con- figuration menu. A list of network devices will be at the top of the page.
3.Select the desired temp sensor and press ENTER. The Device Con- figuration menu will appear.
4.Highlight TEMP TYPE and press ENTER. The following temp options will appear: Water, Outside, Inside, Engine Room, Cabin, Live Well, Bait Well, Refigeration, Heating System and Unknown (default).
5.Highlight the desired Temp Type and press ENTER. The following confirmation message will appear: Are you sure you wish to change this device's configuration?
6.Highlight YES and press ENTER. Press EXIT repeatedly to return to the main display.
25