GSW 319594-000 manual IX Reference Parts, Reference Parts Listing

Page 33

IX) REFERENCE PARTS

Reference Parts Listing

Replacement parts may be ordered through your plumber or the local distributor. When ordering replacement parts, always have the following information ready:

1.Model, Serial and Product number

2.Type of gas

3.Item number

4.Parts description

See "Parts Reference Illustration" for a list of available repair parts.

1.Vent Termination Elbow with Rodent Screen

2.**Vent Pipe

3.**Vent Pipe Coupling (if required)

4.**Vent Pipe Elbow (long radius)

5.Limit Switch

6.T&P Valve

7.Diptube

8.Baffle Assembly

9.Driptube

10.*Gas Control/Thermostat (Robertshaw)

11.Gas Control/Thermostat Cover (Robertshaw)

12.Drain Valve

13.Outer Gas Door

14.Manifold Door Assembly (behind outer door)

15.**Floor Drain

16.**Drain Pan

17.Flammable Vapour Sensor (under cover)

18.Combo Heating System Return Inlet (Optional)

19.Air Inlet Snorkel

20.Combo Heating System Supply Outlet (Optional)

21.Power Cord

22.Air Switch (inside box)

23.Junction Box

24.Junction Box Cover

25.Air Tubing

26.Rubber Coupling

27.Gear Clamp

28.Draft Diverter

29.Hot-Water Outlet Nipple

30.Anode (under cap)

31.Cold-Water Inlet Nipple

32.Flexible Manifold Tube

33.Viewport

34.Hot-Surface Igniter

35.Gas Orifice

36.Sheet Metal Burner

37.Gas Manifold

38.Flame Sensor Rod

39.Manifold Door Gasket

40.Manifold Door

41.Two Piece Grommet With Clip

42.*Gas Control/Thermostat (White-Rodgers) (not shown) * Robertshaw and White-Rodgers systems are not

interchangeable.

** Items not supplied with the water heater.

Part numbers are available on line at: www.johnwoodwater- heaters.com or www.gsw-wh.com.

– 33 –

Image 33

Contents What to do if YOU Smell GAS For Your SafetyViii Troubleshooting Guide Page User Responsibilities IntroductionFor Installations in Canada II SafetyFor Installations in the United States Safety Warning Flammable VapoursFlooding/Freezing Relief Valve Requirements T&PLocation Requirements Valves For Hot Water Supply Systems, Ansi Z21.22/CSAClearances and Accessibility Closet Installation & Floor SurfacesEarthquake Zones Gas Supply Pressure Gas Leak TestingGas line purging Gas Operating PressuresCanadian Installations Air RequirementsVentilated Space Air Requirements for Local Codes InstallationsExhaust Venting General Venting Layout Venting terminations and sizingUse only in well-ventilated areas Use of Solvent Cement and PrimerDo not use near flame or open fire Use only the Solvent Cement and PrimerVent pipe connection to blower Water Supply Filling the Water Heater Piping InstallationTemperature and Pressure Relief Valve Temperature and Pressure T&P Relief ValveClosed System/Thermal Expansion Discharge Line/DriptubeWiring Diagram White-Rodgers Control Flammable Vapour Sensor exploded view Flammable Vapour SensorWater Heater Operation Resettable LockoutInstallation Checklist Mixing Valves IV Operating Instructions CautionRisk of scalding Hot water can produce third degree burnsLighting Instructions Robertshaw System Error Codes Gas Control/ThermostatHeater Shutdown Lighting Instructions White-Rodgers Temperature Adjustment Control is adjusted to its lowest temperature settingApproximately 21C 70F when shipped from factory Symptom Possible Causes Corrective Action Intelli-VentTMSystem Error Codes Heater ShutdownSymptom Possible Causes Corrective Action Operation Burner Flames VI MaintenanceOperational Conditions Draining and FlushingAnode Rod Replacement Routine Preventative MaintenanceGas Control Blower Maintenance VII Combo Heating InstallationSystem Requirements Tice such as Ashrae Handbooks, HraiRobertshaw 2000WDER and White-Rodgers Intelli-VentTM Viii Troubleshooting GuideReference Parts Listing IX Reference PartsInterchangeable Items not supplied with the water heater Robertshaw and White-Rodgers systems are not Interchangeable Parts Reference IllustrationWHO is Covered Limited WarrantyHOW the Original Owner can Make a Warranty Claim