GSW 72090 manual HOW the Original Owner can Make a Warranty Claim

Page 26

d.The water heater or any of its component parts are damaged or fails from operation with an empty or partially empty tank (such as, but not limited to elements burned out in a dry tank); or

e.The water heater or any part has been under water; or

f.The water heater is exposed to highly corrosive atmospheric conditions. No warranty extends, for example, and without limitation of the foregoing, to Units exposed to: salts, chemicals, exhausts, pollutants or contaminants; or

g.The water heater is not continuously supplied with potable water; or

h.The water heater replacement is requested for reasons of noise, taste, odor, discoloration and/or rust; or

i.The water heater is operated at temperatures exceeding the maximum setting of the thermostat and/or high limit control provided by the Manufacturer, or at water pressures exceeding the pressure reading stated on the Unit; or

j.The water heater is operated without an operating anode; or

k.The water heater is supplied or operated with deionized water; or

l.The water heater is removed from its original installation location; or

m.The water heater is installed outdoors (this water heater is intended only for indoor installation); or

n.The water heater is converted, or is attempted to be converted, from one voltage or wattage to another, if an elec- tric water heater, or from one type gas to another, if a gas water heater; or

o.The water heater has not been fired at the factory rated input and fuel for which it was factory built; or

p.The water heater or any of its component parts fail due to sediment build-up; or

q.The water heater does not have installed a properly operating temperature and pressure relief valve, certified to ANSI Z21.22/CSA “Requirements for Relief Valves for Hot Water Supply Systems”; or

r.The water heater or any of its component parts fail because of fire, floods, lightening, or any other act of God, or any other contingency beyond the control of the Manufacturer; or

s.The water heater is installed in a closed system without adequate provision for thermal expansion.

3.Except when specifically prohibited by the applicable law, the Owner, and not the Manufacturer, shall be liable for and shall pay for all charges for labour or other expenses incurred in the removal, repair or replacement of the water heater or any component part(s) claimed to be defective or any expense incurred to remedy any defect in the product. Such charges may include, but are not necessarily limited to:

a.All freight, shipping, handling and delivery costs of forwarding a new water heater or replacement part(s) to the Owner.

b.All costs necessary or incidental in removing the defective water heater or component part(s) and installing a new water heater or component part(s).

c.Any material required to complete, and/or permits required for, installation of a new water heater or replacement part(s), and

d.All costs necessary or incidental in returning the defective water heater or component part(s) to a location desig- nated by the Manufacturer.

4.The terms of this Limited Warranty cannot be modified by any person, whether or not he/she claims to represent or act on behalf of the Manufacturer.

E.HOW THE ORIGINAL OWNER CAN MAKE A WARRANTY CLAIM.

1.The Owner should submit the warranty claim directly to Manufacturer’s Service Department, at the address or phone number listed below, and Manufacturer will arrange for the handling of the claim.

2.Whenever any inquiry or request is made, be sure to include the water heater’s catalogue number, model number, serial number, date of purchase, date of installation, and location of installation.

This warranty and the Manufacturer’s obligations shall be construed and determined in accordance with the laws of both the Province of Ontario, and of Canada in force therein. This Warranty does not affect specific legal rights of a consumer under applicable law, except to the extent that such rights may be waived or replaced, and the provisions hereof are deemed to be amended to the extent necessary. The unenforceability of any provision, in whole or in part, of this Certificate shall not affect the remaining provisions. Any and all repair and/or replacement of part(s) or Unit are the sole and exclusive remedy available against the Manufacturer.

GSW Water Heating

599 Hill Street West

Fergus, ON Canada N1M 2X1

Should you have any questions please Email us at techsupport@gsw-wh.com or Visit our websites: www.gsw-wh.com or www.johnwoodwaterheaters.com or Call our Technical Support line at 1-888-GSW-TECH (479-8324)

GSW Water Heating is a division of A.O.Smith Enterprises Ltd.

– 26 –

Page 25 Page 26
Image 26
Page 25 Page 26
Contents For Your Safety What to do if YOU Smell GASPage Limited Warranty Viii Troubleshooting GuideIX Repair Parts Illustration For Installations in the United States Introduction II SafetyFor Installations in Canada User ResponsibilitiesSafety Warning Carbon Monoxide Safety Warning Flammable VapoursSafety Warning Scalding Backflow PreventionEarthquake Zones Clearances and AccessibilityLocation Requirements Result in a Fire Hazard Failure to Properly Install this Heater MAYGas Supply Gas line purging Gas Leak TestingGas Pressure Local Codes Confined Space Air Requirements for Canadian InstallationsAir Requirements Confined Space Air Requirements for Installations Exhaust Venting Water SupplyDo not plug valve Valve is dripping or leaking, have aLicensed plumber repair it Do not remove valveDischarge Line Installations CheckTemperature And Pressure Relief Valve IV Operating Instructions Water Temperature Regulation Temperature AdjustmentLighting Instructions Robertshaw 110R What to do if YOU Smell GASLighting Instructions Robertshaw 220R Lighting Instructions White-Rodgers 37C AvantChecking the Draft Operation Burner FlamesEmergency Shut Down Operating ConditionsPeriodic Inspection VI MaintenanceDraining and Flushing Temperature and Pressure Relief Valve External Cleaning Flame-arresterResetting and Replacing the Safety TCO Switch VII Combo Heating System RequirementsViii Troubleshooting Guide Problem Possible Causes CorrectionThermostat Fails to Shut IX Repair Parts Illustration Repair PartsLimited Warranty WHO is CoveredHOW the Original Owner can Make a Warranty Claim

72090 specifications

The GSW 72090 is a remarkable addition to the world of modern heating solutions, designed to provide efficient and effective space heating. It epitomizes advanced technology, reliability, and user-centric design, making it an ideal choice for homes and commercial spaces alike.

One of the main features of the GSW 72090 is its impressive heating capacity. Engineered to deliver optimal warmth, it can efficiently heat larger areas, ensuring that spaces remain comfortable even during the coldest months. The unit’s high-grade alloy construction enhances durability and helps maintain consistent performance over time.

A vital technology integrated into the GSW 72090 is its modulating control system. This system intelligently adjusts the temperature output based on the current heating demand, optimizing energy usage and contributing to lower utility bills. This efficiency not only benefits the consumer but also has a positive impact on the environment by reducing greenhouse gas emissions.

The GSW 72090 also boasts a sleek and modern aesthetic, making it an attractive addition to any space. Its design allows for easy installation and maintenance, ensuring that users can focus on comfort without worrying about the complexities of upkeep. The unit operates quietly, providing a peaceful environment without the disruptive noises often associated with traditional heating systems.

Incorporating safety features is another key characteristic of the GSW 72090. It includes overheat protection, which automatically turns the unit off if it detects excessive temperatures, ensuring a safe environment for occupants. Additionally, the product is constructed with materials that are resistant to corrosion and wear, enhancing longevity.

As an environmentally conscious option, the GSW 72090 is designed to comply with stringent energy efficiency regulations. Its performance not only meets but often exceeds the required standards, making it a smart choice for those looking to reduce their carbon footprint.

Overall, the GSW 72090 stands out due to its combination of advanced technologies, user-friendly features, aesthetic appeal, and commitment to safety and efficiency. Its multi-faceted capabilities make it a prime option for anyone seeking reliable and effective heating solutions in their home or business.
Top Page Image Contents