Integra DTR-6.4/5.4 Connecting the power cords from other devices, Connecting your AV components

Page 23

Connecting the power cords from other devices

Connecting your AV components

Connecting the power cords from other devices

The DTR-6.4/5.4 is equipped with AC mains outlet(s) for connecting the power cords from other device(s) so that their power is supplied through the DTR-6.4/5.4. By doing this, you can leave the connected device turned on and have the Standby/On button on the DTR-6.4/5.4 turn on and off the device together with the DTR-6.4/5.4.

The shape, number, and total capacity of the AC outlets may differ depending on the area of purchase.

Caution:

Make sure that the total capacity of the components connected to the DTR-6.4/5.4 does not exceed the capacity that is printed on the rear panel (e.g., TOTAL 120W).

AC OUTLET

AC 230-240V 50 Hz		AC OUTLETS
SWITCHED 100W MAX.

AC 120V 60 Hz

SWITCHED

TOTAL 120W 1A MAX.

Australian models USA and Canadian models

Connecting the auxiliary power ampliﬁer (DTR- 6.4 only)

These jacks are for connecting an auxiliary power ampliﬁer.

You can use an auxiliary power ampliﬁers to listen at louder volumes than you can with the DTR-6.4 alone. When using a power ampliﬁer, connect each speaker to the power ampliﬁer.

See page 17 for information regarding how to connect to a subwoofer.

				SUR
NCE	ZONE 2	FRONT	SURR CENTER SURR BACK	BAC
ER			(SB)	SPE
		L	L
		R	R
			SUB
			WOOFER

R (red)	L (white)	R (red)	L (white)	R (red)	L (white)
Front			Surround	Center	Surround back
			Power amplifier



		1				2				3				4				5			6				7

1.	Front right speaker															5.	Center speaker
2.	Front left speaker															6.	Surround back right
3.	Surround right																speaker
	speaker															7.	Surround back left speaker
4.	Surround left speaker

Note:

If you use a power ampliﬁer connected to the SURR BACK PRE OUT terminal and connect two surround back speakers to the ampliﬁer, set the “Hardware Conﬁg” → “b. Surr Back” setting to “2ch (PRE OUT)” (see page 32).

23

Image 23

Contents Basic Settings ContentsBefore using Setting up your DTR-6.4/5.430AVIS Important Safety InstructionsFor U.S. models Note to CATV system installer PrecautionsSupplied accessories 4. PowerConnecting the remote zone Zone 2 speakers ContentsBefore using Connecting your AV componentsProgramming the commands of remote ContentsConﬁguring your DTR-6.4/5.4Advanced Settings Remote controllerAmpliﬁer Features FeaturesDTR-6.4 DTR-5.4Using the remote controller Before using this unitConnecting the power cord Installing the remote controller batteriesDTR-6.4Front panel DTR-5.4Front panel Index parts and facilitiesIndex parts and facilities MEMORY indicator Front panel displayTUNED indicator AUTO indicatorIndex parts and facilities Rear panelIR IN/OUT Remote controllerIndex parts and facilities MONITOR OUT VIDEO/S VIDEOIndex parts and facilities Send/Learn indicatorCenter speaker About HomeTheaterEnjoying Home Theater For DTR-6.4onlyTerminal shapes AV cables and connectorsImproper connection Inserted completely Cable formsSurround back speaker placement Connecting speakersConnecting a subwoofer Connecting speakersConnecting the speaker cables Using the speaker cable labels2. Connecting a turntable PHONO DTR-6.4only Connecting your AV componentsConnecting your audio components 1. Connecting a compact disc player CDCOMPONENT VIDEO INPUT/OUTPUT Connecting your AV componentsConnecting your video components The ﬂow of the video signals5. Connecting a DVD player DVD Connecting your AV components6. Connecting a video cassette recorder VIDEO Connecting your AV components9. Connecting video camera, etc. Video 4 Input Connecting your AV componentsConnecting your AV components Connecting the power cords from other devicesAssembling the AM loop antenna Connecting antennasConnecting the AM antenna cable Connecting the included antennasDirectional linkage Connecting antennasConnecting an FM outdoor antenna Connecting an AM outdoor antennaWhen using the ZONE 2 PRE OUT terminals Connecting the remote zone Zone 2 speakersWhen using the ZONE 2 SPEAKERS terminals When using the ZONE 2 LINE OUT terminalsFrom connecting block Mini plug cable A-BUS Connections for remote controlMiscellaneous Connections RS232Turning on the power from the remote controller Connecting the powerTurning on the power 53,55 Setup Menu52,54 Buttons used for navigating through the menus Setup Menub. Surr Back DTR-6.4only Hardware Conﬁga. Surr/Zone crosscover frequency Speaker ConﬁgurationAdjustable Crossover for Bass Management Front speaker diameterNotes Front speaker diametercrosscover frequency a. Digital InputChanging the display Return Setup TapeReturn Setup ENTERLight button on the remote controller DTR-6.4only Enjoying music or videos with the DTR-6.4/5.4Basic operation Enjoying music or videos with the DTR-6.4/5.4 Using the sleep time remote controller onlyListening with headphones Adjusting the brightness of the front displayNotes Switching the displayTemporarily changing the speaker output levels Enjoying music or videos with the DTR-6.4/5.4Notes on DTS Selecting the type of audio input signalEnjoying music or videos with the DTR-6.4/5.4 NotesBasic operation Using the tone controlEnjoying DVD multichannel audio playback Changing the listening mode DTR-6.4only Enjoying DVD multichannel audio playbackListening to a stereo radio station FM mode Tuning into a radio stationListening to Radio Broadcasts Listening to Radio Broadcasts Presetting a radio stationSelecting a preset radio station Erasing a preset radio stationMono Listening ModesListening Modes T-D Theater-DimensionalEnhance Listening Modes• THX Surround EX Mono MovieListening Modes Selecting a listening mode DTR-6.4Re-EQfunction for movies DTR-6.4only Listening Modes Selecting a listening mode DTR-5.4•While playing back DTS sources THX Cinema Fixing playback to speciﬁc surround modeListening Modes •While playing back DTS sourcesUsing the remote controller Using the buttonsAdjusting the volume for the remote zone Enjoying music in the remote zoneNotes RecordingRecording the input source Rec Out selector NotesHint RecordingRecording both the audio and video Notes Conﬁguring the speakers DTR-6.4Notes Conﬁguring the speakers DTR-6.4Calibrating the speaker levels Return Conﬁguring the speakers DTR-5.4Setup Return SetupCalibrating the speaker levels Conﬁguring the speakers DTR-5.4Using the remote controller the procedureInput Setup e. PCM fs 96kHz source Input SetupConﬁguring the listening modes frequently you use d. Analog/PCM/D. F. 2ch sourceChanging the volume level display setting Adjusting the headphones volume levelSetting the background color for OSD Switching the OSD display modeTreble Audio AdjustBass Late Night Audio AdjustPro Logic II Music Dimension Dimension Double BassReverb Time Settings available when you play monaural signalAudio Adjust Reverb LevelControlling an Onkyo cassette tape deck Using remote controllerCalling up a preset radio station OverviewControlling an Integra/Onkyo DVD player Using remote controllerDisc Controlling an Integra/Onkyo CD playerUsing remote controller 1. Press the CD Mode button1 to 9, 0, --/---: Numeric keys Controlling an Onkyo MD recorderUsing remote controller Rec : RecordLearning a pre-programmingcode Entering a pre-programmingcodePre-programmingcodes Entering a pre-programmingcodeCable Mode Cable Mode Operating your programmed remote controllerDVD Mode DVD Player Mode SAT Mode Satellite Tuner Mode0,1 to 9, +10: Numeric keys Operating your programmed remote controllerVCR Mode VCR Mode TV Mode TV ModeProgramming procedure Notes Erasing the programmed command from one buttonNotes Executing the macro Using the macro functionWhat is the macro function? Programming the macroNotes Using the macro functionErasing a macro from the Macro 1 or 2 button NotesTUNER SECTION Speciﬁcations DTR-6.4REMOTE CONTROLLER AMPLIFIER SECTIONTUNER SECTION Speciﬁcations DTR-5.4REMOTE CONTROLLER AMPLIFIER SECTIONFM/AM TUNER Troubleshooting guidePOWER SPEAKERSOTHER Troubleshooting guideREMOTE CONTROLLER VIDEO and AUDIO“Not available with this signal” If one of the messages shown below appearsTroubleshooting guide “Not available with headphones use”Memo Printed in Japan Integra Division of ONKYO U.S.A. CORPORATIONIntegra Division of ONKYO CORPORATION Tel: 072-831-8111Fax: