Integra Enjoying music or videos with the DTR-6.4/5.4, Temporarily turning off the sound

Enjoying music or videos with the DTR-6.4/5.4

Dimmer

Phones

Temporarily turning off the sound

To turn off the sound momentarily, press the	Remote
Muting button on the remote controller. The	controller
Muting indicator will flash and the sound from the
		Muting
speakers or headphones will be switched off by		M
the receiver’s audio muting circuit. Press the
Muting button again to turn the sound back on.
Flashes

RC-534M

Sleep

CH				VOL
Disc
TV / VCR		Level		Muting	Muting
Audio Sel
A	Angle			Subtitle M
Random				Audio Adjust
	Rec
		Input Selector
	DVD			CD
	V 1	V 2	TAP	TUN
	V 3	V 4	V 5	PH
	1	2		3
	Pure A	Direct		Stereo
	4	5		6
	SURR	THX		All ST
	7	8		9
	DSP	DSP		Re-EQ
	+10	0		Search
	Display	Dimmer		Zone 2	Dimmer
	-- / ---			Enter

Using the sleep time (remote controller only)

The Sleep button enables you to set the DTR-6.4/5.4 to turn off automatically after a specified time period. If you press it once, the DTR-6.4/5.4 will turn off after 90 minutes. Each time it is pressed thereafter, this remaining time until the DTR-6.4/5.4 turns off decreases by 10 minutes (i.e., from 90 to 80 minutes). While the sleep function is enabled, you can press the Sleep button to see how much time is left. If the Sleep button is pressed when the time displayed is less than 10 minutes, the sleep function is cancelled.

Remote controller

Listening with headphones

To listen with headphones, plug a pair of headphones with a standard stereo plug into the Phones jack on the DTR-6.4/5.4 front panel.

When you connect the headphones, the DTR-6.4/5.4 will enter the STEREO mode automatically and no sound will be heard from the speakers. When the headphones are unplugged, the DTR-6.4/5.4 returns to its original listening mode. When using the headphones, you can only use the Direct, Stereo, and Pure Audio (DTR-6.4 only) listening modes. If you have selected multichannel audio, you will only hear the sound output to the front right and left channels.

The headphone volume level can be adjusted at the Setup Menu (see page 58).

Note:

The signal to the remote zone (Zone 2) will not be affected by whether or not headphones are connected

If you are using the remote zone (Zone 2), it will turn off at the same time as the main zone. If you want to set the sleep function for Zone 2 only, set the sleep function with the main zone turned on and then put the main zone into the standby state.

Adjusting the brightness of the front display

You can adjust the brightness of the front display of the DTR-6.4/

5.4using the Dimmer button on the remote controller or on the DTR-6.4/5.4 front panel.

DTR-6.4/5.4	Remote controller
	0
	Dimmer

37