Integra DTR-6.4/5.4 instruction manual Connecting antennas, Assembling the AM loop antenna, Hint

Page 24
Connecting antennas

Connecting antennas

To use the tuner of the DTR-6.4/5.4, it is necessary to prepare the supplied FM and AM antennas.

Adjustment and placement of the FM and AM antennas for better reception must be done while listening to a station broadcast.

If better reception cannot be obtained, then placement of an outside antenna is recommended.

Assembling the AM loop antenna

Assemble the loop antenna as shown in the illustration.

Refer to “Connecting the AM loop antenna” below for details on how to connect the loop antenna.

Insert into the hole

Connecting the AM antenna cable

1.Press down the lever at the antenna terminal.

2.Insert the wire into the terminal hole.

3.Release the lever.

1

2

3

Connecting the included antennas

Connecting the FM indoor antenna:

The FM indoor antenna is for indoor use only. During use, extend the antenna and adjust its orientation until the clearest signal is received. Fix it with push pins or similar items in the position that will cause the least amount of distortion.

If the reception is not very clear with the attached FM indoor antenna, the use of an outdoor antenna is recommended.

Connecting the AM loop antenna:

The AM loop antenna is for indoor use only. Set it in the direction and position where you receive the clearest sound. Put it as far away as possible from the DTR-6.4/5.4, televisions, speaker cables, and power cords.

If the reception is not very clear with the attached AM indoor antenna, the use of an outdoor antenna is recommended.

FM antenna

(Indoor)

AM loop antenna

Australian models

ANTENNA

AM

FM 75

 

12 V

 

 

 

 

ZONE 2

TRIGGER

 

IR OUT

 

 

OUT

 

ZONE 2

DC IN

LINE OUT

56K

40K

 

 

 

OUT

24V 1A

 

A

A

L

 

B

 

USA and Canadian models

Hint:

Either of the split ends of the AM antenna can be connected to either terminal. Unlike speaker cabling, there is no polarity for AM broadcast signals.

24

Image 24
Contents Contents Before usingSetting up your DTR-6.4/5.430 Basic SettingsImportant Safety Instructions AVISPrecautions Supplied accessories4. Power For U.S. models Note to CATV system installerContents Before usingConnecting your AV components Connecting the remote zone Zone 2 speakersContents Configuring your DTR-6.4/5.4Advanced SettingsRemote controller Programming the commands of remoteFeatures DTR-6.4DTR-5.4 Amplifier FeaturesBefore using this unit Connecting the power cordInstalling the remote controller batteries Using the remote controllerIndex parts and facilities DTR-6.4Front panel DTR-5.4Front panelIndex parts and facilities Front panel display TUNED indicatorAUTO indicator MEMORY indicatorRear panel Index parts and facilitiesRemote controller Index parts and facilitiesMONITOR OUT VIDEO/S VIDEO IR IN/OUTSend/Learn indicator Index parts and facilitiesAbout HomeTheater Enjoying Home TheaterFor DTR-6.4only Center speakerAV cables and connectors Improper connection Inserted completelyCable forms Terminal shapesConnecting speakers Surround back speaker placementConnecting speakers Connecting the speaker cablesUsing the speaker cable labels Connecting a subwooferConnecting your AV components Connecting your audio components1. Connecting a compact disc player CD 2. Connecting a turntable PHONO DTR-6.4onlyConnecting your AV components Connecting your video componentsThe flow of the video signals COMPONENT VIDEO INPUT/OUTPUTConnecting your AV components 5. Connecting a DVD player DVDConnecting your AV components 6. Connecting a video cassette recorder VIDEOConnecting your AV components 9. Connecting video camera, etc. Video 4 InputConnecting the power cords from other devices Connecting your AV componentsConnecting antennas Connecting the AM antenna cableConnecting the included antennas Assembling the AM loop antennaConnecting antennas Connecting an FM outdoor antennaConnecting an AM outdoor antenna Directional linkageConnecting the remote zone Zone 2 speakers When using the ZONE 2 SPEAKERS terminalsWhen using the ZONE 2 LINE OUT terminals When using the ZONE 2 PRE OUT terminalsFrom connecting block Mini plug cable Connections for remote control Miscellaneous ConnectionsRS232 A-BUSConnecting the power Turning on the powerTurning on the power from the remote controller Setup Menu 52,5453,55 Setup Menu Buttons used for navigating through the menusHardware Config a. Surr/Zoneb. Surr Back DTR-6.4only Speaker Configuration Adjustable Crossover for Bass ManagementFront speaker diameter crosscover frequencyFront speaker diameter crosscover frequencya. Digital Input NotesReturn Setup Tape Return SetupENTER Changing the displayEnjoying music or videos with the DTR-6.4/5.4 Basic operationLight button on the remote controller DTR-6.4only Using the sleep time remote controller only Listening with headphonesAdjusting the brightness of the front display Enjoying music or videos with the DTR-6.4/5.4Switching the display Temporarily changing the speaker output levelsEnjoying music or videos with the DTR-6.4/5.4 NotesSelecting the type of audio input signal Enjoying music or videos with the DTR-6.4/5.4Notes Notes on DTSUsing the tone control Enjoying DVD multichannel audio playbackBasic operation Enjoying DVD multichannel audio playback Changing the listening mode DTR-6.4onlyTuning into a radio station Listening to Radio BroadcastsListening to a stereo radio station FM mode Presetting a radio station Selecting a preset radio stationErasing a preset radio station Listening to Radio BroadcastsListening Modes Listening ModesT-D Theater-Dimensional MonoListening Modes • THX Surround EXMono Movie EnhanceSelecting a listening mode DTR-6.4 Re-EQfunction for movies DTR-6.4onlyListening Modes Selecting a listening mode DTR-5.4 Listening ModesFixing playback to specific surround mode Listening Modes•While playing back DTS sources •While playing back DTS sources THX CinemaUsing the buttons Adjusting the volume for the remote zoneEnjoying music in the remote zone Using the remote controllerRecording Recording the input source Rec Out selectorNotes NotesRecording Recording both the audio and videoHint Configuring the speakers DTR-6.4 NotesConfiguring the speakers DTR-6.4 Calibrating the speaker levelsNotes Configuring the speakers DTR-5.4 Setup ReturnSetup ReturnConfiguring the speakers DTR-5.4 Using the remote controllerthe procedure Calibrating the speaker levelsInput Setup Input Setup Configuring the listening modes frequently you used. Analog/PCM/D. F. 2ch source e. PCM fs 96kHz sourceAdjusting the headphones volume level Setting the background color for OSDSwitching the OSD display mode Changing the volume level display settingAudio Adjust BassTreble Audio Adjust Pro Logic II Music Dimension DimensionDouble Bass Late NightSettings available when you play monaural signal Audio AdjustReverb Level Reverb TimeUsing remote controller Calling up a preset radio stationOverview Controlling an Onkyo cassette tape deckUsing remote controller Controlling an Integra/Onkyo DVD playerControlling an Integra/Onkyo CD player Using remote controller1. Press the CD Mode button DiscControlling an Onkyo MD recorder Using remote controllerRec : Record 1 to 9, 0, --/---: Numeric keysEntering a pre-programmingcode Learning a pre-programmingcodeEntering a pre-programmingcode Pre-programmingcodesOperating your programmed remote controller DVD Mode DVD Player ModeSAT Mode Satellite Tuner Mode Cable Mode Cable ModeOperating your programmed remote controller VCR Mode VCR ModeTV Mode TV Mode 0,1 to 9, +10: Numeric keysProgramming procedure Erasing the programmed command from one button NotesNotes Using the macro function What is the macro function?Programming the macro Executing the macroUsing the macro function Erasing a macro from the Macro 1 or 2 buttonNotes NotesSpecifications DTR-6.4 REMOTE CONTROLLERAMPLIFIER SECTION TUNER SECTIONSpecifications DTR-5.4 REMOTE CONTROLLERAMPLIFIER SECTION TUNER SECTIONTroubleshooting guide POWERSPEAKERS FM/AM TUNERTroubleshooting guide REMOTE CONTROLLERVIDEO and AUDIO OTHERIf one of the messages shown below appears Troubleshooting guide“Not available with headphones use” “Not available with this signal”Memo Integra Division of ONKYO U.S.A. CORPORATION Integra Division of ONKYO CORPORATIONTel: 072-831-8111Fax: Printed in Japan