
Before using this unit
Connecting the power cord
Plug the supplied power cord into this AC INLET.
•Do not use a power cord other than the one supplied with the
•Never have the power cord disconnected from the
AC INLET
Power cord (supplied)
DO NOT connect the power cord at this time.
Note:
The shape of the power cord plug will be different depending on the shipping area.
Installing the remote controller batteries
1.Remove the battery compartment cover by pressing it and sliding it in the direction shown by the arrow below.
2.Insert two AA (or R6) batteries into the battery
compartment. Carefully follow the polarity diagram
(positive and negative
symbols) inside the battery compartment.
3.After the batteries are installed and seated correctly, replace the compartment cover.
1 | 2 | 3 |
Notes:
•Do not mix new batteries with old batteries or different kinds of batteries.
•To avoid corrosion, remove the batteries if the remote controller will not be used for a long time.
•Remove dead batteries immediately to avoid damage from corrosion. If the remote controller does not operate smoothly, remove the old batteries and replace them both with two new AA batteries.
Using the remote controller
Point the remote controller toward the remote control sensor. The Standby indicator lights up when the unit receives a signal from the remote controller.
Remote control sensor |
Standby indicator
30˚
30˚
Approx. 16 feet (5 meters)
Send/Learn indicator
Notes:
•Make sure that the remote control sensor is not subject to strong light such as direct sunlight or inverted fluorescent light for it may prevent proper operation of the remote controller.
•Using another remote controller in the same room or using the
•Do not put objects on the remote controller. Its buttons may be pressed by mistake and drain the batteries.
•Make sure the audio rack doors do not have colored glass. Placing the
•If there is any obstacle between the remote controller and the remote control sensor, the remote controller will not operate.
7