Remote Control Preparation
CAUTION! Do not connect the batteries to the remote control receiver until the wires are connected to the burner control unit, as short circuit could result in destruction of the electrical components.
1.Connect the wiring harness to the receiver box by pushing the wire connector on to the receiver circuit board. The plug will only go on one way so please ensure that the wires are pointing up and the slot in the board is in line with the tab on the wiring harness plug.
2.Connect the wires “A” (with the “L” terminals) to the connectors “B” on the control valve. Please note that the connectors are different sizes; the smaller one fits to the lower connection on the valve.
3.Connect the wires “C” to the connectors “D” on the control valve. (Either wire can be fitted to either connector.)
4.Remove the remote control receiver lid.
5.Fit four 1.5 V batteries. Refit the lid.
6.Place the remote control receiver of the Velcro pad.
7.Fit the 9 V battery to the handset transmitter.
D
B
Remote control receiver
Receiver | Cable |
Sensor Opening
LED (green)
C A
16